[Z06] UD Pulley
#1
Drifting
Thread Starter
UD Pulley
I found a Lingenfelter UD Pulley on CL for dirt cheap, it is an ATI unit. Would it be worth upgrading and what power would it be good for?
#4
Drifting
Thread Starter
Eh, I will pass.
#5
Race Director
Member Since: Mar 2006
Location: Everywhere and Nowhere at all
Posts: 15,357
Received 1,679 Likes
on
1,135 Posts
ATI 10%.. do it Ben!
#7
Le Mans Master
This is one of those mods that I wish I did with the cam, cause now I have to tear the car apart again just to install it.
OP: If you don't have an ARP bolt yet, I'll give you this one. Just pay shipping. I already have a ARP bolt.
Last edited by jayyyw; 04-30-2018 at 07:40 PM.
#8
I just bought one for, what I think, was a great deal. $275 with an ARP bolt.
This is one of those mods that I wish I did with the cam, cause now I have to tear the car apart again just to install it.
If you don't have an ARP bolt yet, I'll give you this one. Just pay shipping. I already have a ARP bolt.
This is one of those mods that I wish I did with the cam, cause now I have to tear the car apart again just to install it.
If you don't have an ARP bolt yet, I'll give you this one. Just pay shipping. I already have a ARP bolt.