[Z06] AHP 112 Cam
#1
Racer
Thread Starter
AHP 112 Cam
Well since I haven't seen anyone post anything about how much power they have made with an AHP 112. I figured I would start my own thread regarding this. I just got back my AHP CNC'd heads and milled to .030 along with Johnson 2110 lifters with che rockers. I have kooks long tube headers with high flow cats, Nicky Williams throttle body, and halltech 108. Lastly I have installed a MSD intake manifold, so hopefully in the next two weeks I get this taken to kohle and have AHP tune this to what this beast has for rwhp.
#2
Racer
Well since I haven't seen anyone post anything about how much power they have made with an AHP 112. I figured I would start my own thread regarding this. I just got back my AHP CNC'd heads and milled to .030 along with Johnson 2110 lifters with che rockers. I have kooks long tube headers with high flow cats, Nicky Williams throttle body, and halltech 108. Lastly I have installed a MSD intake manifold, so hopefully in the next two weeks I get this taken to kohle and have AHP tune this to what this beast has for rwhp.
I'm for results.
#5
Racer
Thread Starter
#8
Nicely done! Is that just regular painters tape on the fenders? I'm going to be pulling the heads in a month or so and I've seen this painters tape trick, and I've also seen a few shops (like RPM come to mind) that use almost like a saran wrap on the front end of the car. I could never figure out what exactly they were putting on those. Has the painters tape held up?
#10
Intermediate
That cam is the btr4 cam right? get some headers a CAI a ported MSD and ported heads and you will fall in love with the car I promise 600WHP in these cars are just absolutely insane! im telling you!
#12
Team Owner
#13
Supporting Vendor
Member Since: Sep 2013
Location: Harbor City California
Posts: 2,815
Received 1,012 Likes
on
533 Posts
Hey Mark!
Great Thread!!!When you get everything back together give us a call/email and we will get you setup to get your z06 on the Dyno!
Should put down some very nice numbers!!!
Last edited by American Heritage; 01-31-2019 at 05:50 PM.
#14
Racer
Thread Starter
No I said it was an AHP 112 cam note the title of the thread. I ordered everything through AHP minus the msd, halltech and headers. As I already stated in my opening post.
#15
Racer
Thread Starter
#16
Racer
Thread Starter
front end is back together now with the drm shocks and new brake ducting finished. Now I have to put back in the factory mufflers and drm shocks in the rear. Then it will be a couple weeks to get her hauled off to AHP to get tuned.
Last edited by Mark Leger; 01-31-2019 at 08:40 PM.
#17
Melting Slicks
Member Since: Jun 2005
Location: Rochester NY
Posts: 2,734
Received 1,678 Likes
on
878 Posts
2018 C6 of Year Finalist
St. Jude Donor '10, '17
Looking good Mark! Nice work so far. Hoping you can get her on the track soon! She will be a beast. I'm going to try to make it to the West Coast either this year or next.
#19
Racer
Thread Starter
Well looking like I'm going to get tuned on the 20th of Feb as soon as I get confirmation. So, I'll try to get a video up and pictures of the results. More importantly looking forward to getting it on the track.