08 JSB A6 4LT STS twin turbo!
11-01-2009, 10:02 PM
#1
Burning Brakes
Thread Starter
Member Since: Mar 2008
Location: Nassau NewYork
Posts: 1,015
Likes: 0
Received 0 Likes
on
0 Posts
08 JSB A6 4LT STS twin turbo!
BACK ON THE MARKET!! looking for a quick sale on this car, so im looking for serious buyers only. located in rosyln heights, NY. car has only 15,000 miles! built motor is brand new! originally asking 65k! dont miss this deal.
$50,000 OBO
short rev vid
http://youtu.be/x21odh8F_N0
performance mods:
-ARH long tube headers, mid section. catless.
-Elite Engineering tunnel plate w/ thermal abs
-Vette Doctors blower cam
-PTB by Vmax. a forum vendor.
-STS twin turbo kit. Upgraded 60-1 turbos good for 1000hp!
-STS upgraded exhaust tips with STS logo
-STS Boost Controller. mounted in glove box.
-STS Meth kit. tuned to come on at 4k RPM's on high boost. uses windshield wiper container.
-fuel lines wraped in thermal wrap from S&K Speed.
-all oil lines zip tied every 6 inches or so, SUPER clean install. Have many pics if requested.
- Built engine by Vette Doctors in October 2009, has about 300 miles on it and 1500 miles with a 3,000RPM limit to break the engine in. all forged internals. built for boost.
-Zo6 brake upgrade and SS lines from TKO performance, painted JSB by Mike the Powdercoater.
-Dewitts high proformance raditator from WCC.
-Protorque torque convertor from WCC. 2800 stall
-Oil cooler by Vette Doctors
-Line Locks, from a GB on the forum (forgot vendor) switch installed on cluster.
Exterior:
-glass top option
-Zo6 rear conversion by Gene Cully, mesh grilles painted black
-20' 360 forged Mesh10. custom finish JSB iner barrel&lip, gloss black face. reverse fasteners. Nitto Invo tires all around, 345 in the rear. bought the rims in sept, less then 3k on them. tires were mounted,balanced,installed with new sensors, by 360.
-black zo6 repos by TKO, 18',19' with invos all around w/ 345 in the rear. i bought these when i did the widebody. wheels have 5k on them. buyer may have these for FREE. custom JSB painted pinstripe
-M/T 18x345 ET street tires, BRAND NEW. offered to buyer for FREE
- MCM carbon fiber hood with clear center option. purchased from WCMC.
-custom black emblems w/ silver outline
-WCC zo6 style front splitter painted JSB w/ black screen. installed professionally w/ better nuts&bolts.
- 3m clear protection film installed by Detailing Dynamics first week of car purchase. front nose, sideskirts, wheel wells
-8000K headlights&foglights w/ clear turn signal/running lamp
-20%tints
-RPI JSB pillars
-black painted reflectors, front and rear.
-custom painted LED tail lights. professionally done at a body shop.
-factory zo6 rear spoiler JSB.
-factory JSB body color license plate frame
AUTO TRANNY RECENTLY BUILT BY FRED AND MIKE AT FB PERFORMANCE. VERY WELL KNOWN TRANNY BUILDER OUT ON LONGISLAND IN BAYSHORE. feel free to call mike or fred and ask about the build and the car!
-red packs, all seals and gaskets. built to the max. Shifts are seemless. Could not be happier with this trans. Only has about 1000 miles on the new tranny as of 6/20/2012
CAR WAS RECENTLY TUNED BY ENZO AT ENZO PERFORMANCE ALSO IN BAYSHORE LI, DOWN THE BLOCK FROM FB PERFORMANCE. PLEASE PM ME FOR INFO, AND FEEL FREE TO ASK TO SPEAK TO ENZO ABOUT THIS CAR, THE TUNE, AND THE TRANNY TUNE. ENZO IS A VERY RESPECTED CAR TUNER AND AN AWESOME GUY.
Interior
-4LT ebony& linnen
-DSV D-style steering wheel w/ alacatra sides and linnen stiching.
- "A" pillar gauge pod with autometer sport comp boost and AF digital
- White carbon fiber floor console base and ebrake from APSIS
-GM pattern gauge cluster and center console from TKO
-PFADT 4 pt roll cage. installed by Vette Doctors.
-hard wire for valentine 1 radar near mirror
some shots:
exhaust tips have been fixed since these
$50,000 OBO
short rev vid
http://youtu.be/x21odh8F_N0
performance mods:
-ARH long tube headers, mid section. catless.
-Elite Engineering tunnel plate w/ thermal abs
-Vette Doctors blower cam
-PTB by Vmax. a forum vendor.
-STS twin turbo kit. Upgraded 60-1 turbos good for 1000hp!
-STS upgraded exhaust tips with STS logo
-STS Boost Controller. mounted in glove box.
-STS Meth kit. tuned to come on at 4k RPM's on high boost. uses windshield wiper container.
-fuel lines wraped in thermal wrap from S&K Speed.
-all oil lines zip tied every 6 inches or so, SUPER clean install. Have many pics if requested.
- Built engine by Vette Doctors in October 2009, has about 300 miles on it and 1500 miles with a 3,000RPM limit to break the engine in. all forged internals. built for boost.
-Zo6 brake upgrade and SS lines from TKO performance, painted JSB by Mike the Powdercoater.
-Dewitts high proformance raditator from WCC.
-Protorque torque convertor from WCC. 2800 stall
-Oil cooler by Vette Doctors
-Line Locks, from a GB on the forum (forgot vendor) switch installed on cluster.
Exterior:
-glass top option
-Zo6 rear conversion by Gene Cully, mesh grilles painted black
-20' 360 forged Mesh10. custom finish JSB iner barrel&lip, gloss black face. reverse fasteners. Nitto Invo tires all around, 345 in the rear. bought the rims in sept, less then 3k on them. tires were mounted,balanced,installed with new sensors, by 360.
-black zo6 repos by TKO, 18',19' with invos all around w/ 345 in the rear. i bought these when i did the widebody. wheels have 5k on them. buyer may have these for FREE. custom JSB painted pinstripe
-M/T 18x345 ET street tires, BRAND NEW. offered to buyer for FREE
- MCM carbon fiber hood with clear center option. purchased from WCMC.
-custom black emblems w/ silver outline
-WCC zo6 style front splitter painted JSB w/ black screen. installed professionally w/ better nuts&bolts.
- 3m clear protection film installed by Detailing Dynamics first week of car purchase. front nose, sideskirts, wheel wells
-8000K headlights&foglights w/ clear turn signal/running lamp
-20%tints
-RPI JSB pillars
-black painted reflectors, front and rear.
-custom painted LED tail lights. professionally done at a body shop.
-factory zo6 rear spoiler JSB.
-factory JSB body color license plate frame
AUTO TRANNY RECENTLY BUILT BY FRED AND MIKE AT FB PERFORMANCE. VERY WELL KNOWN TRANNY BUILDER OUT ON LONGISLAND IN BAYSHORE. feel free to call mike or fred and ask about the build and the car!
-red packs, all seals and gaskets. built to the max. Shifts are seemless. Could not be happier with this trans. Only has about 1000 miles on the new tranny as of 6/20/2012
CAR WAS RECENTLY TUNED BY ENZO AT ENZO PERFORMANCE ALSO IN BAYSHORE LI, DOWN THE BLOCK FROM FB PERFORMANCE. PLEASE PM ME FOR INFO, AND FEEL FREE TO ASK TO SPEAK TO ENZO ABOUT THIS CAR, THE TUNE, AND THE TRANNY TUNE. ENZO IS A VERY RESPECTED CAR TUNER AND AN AWESOME GUY.
Interior
-4LT ebony& linnen
-DSV D-style steering wheel w/ alacatra sides and linnen stiching.
- "A" pillar gauge pod with autometer sport comp boost and AF digital
- White carbon fiber floor console base and ebrake from APSIS
-GM pattern gauge cluster and center console from TKO
-PFADT 4 pt roll cage. installed by Vette Doctors.
-hard wire for valentine 1 radar near mirror
some shots:
exhaust tips have been fixed since these
Last edited by james1990; 06-19-2012 at 04:48 PM. Reason: PRICE DROP!
11-02-2009, 05:16 PM
#8
Race Director
Awesome car, good luck with the sale!
11-02-2009, 08:41 PM
#11
Heel & Toe
Member Since: Oct 2009
Location: MIAMI FL
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Hello,interested in your car. I've got a few questions, has it ever been involved in any type accident? Clean carfax? Do you have any interior shots? Is JSB the original color?
11-04-2009, 09:34 AM
#13
Burning Brakes
Thread Starter
Member Since: Mar 2008
Location: Nassau NewYork
Posts: 1,015
Likes: 0
Received 0 Likes
on
0 Posts
not sure if a 335 has enough ***** for me coming out of this car
11-04-2009, 10:12 AM
#14
Burning Brakes
Thread Starter
Member Since: Mar 2008
Location: Nassau NewYork
Posts: 1,015
Likes: 0
Received 0 Likes
on
0 Posts
just to give everyone an idea. my father and I collect and build street rods. we take care of all of our cars as if they were show cars. this c6 has been respected, and taken care of to the full extent. 
11-21-2009, 06:10 PM
#16
1st Gear
Member Since: Nov 2009
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
One of a few
This is my first post here.
I'm very interested in this vehicle. I have been watching it since it first appeared. The (non-vehicle related) content of the post seems to have changed a couple different times. I guess that's not a big deal but it does have me curious.
I am somewhat in the category of the "If only's" here, "if only this" "if only that". The reason being because I have a windfall of cash coming, hopefully in December, and I will have the means to make this sports car dream happen after decades of saying "if only".
My credit is good too but I'm unsure if I want to deal with another monthly bill.
I have been interested in 2 other cars here, The "Silver Devil" by ChrisWTX and Georges vert twin turbo.
I am way into having the power potential all these cars possess but will not likely use it that much. The question I am pondering is the amount I will have to be turning wrenches on these critters regularly if/when I make the move to purchase.
Regardless, we'll see how things look when "if only" time becomes "yah baby" time.
Loved the car James. It's a beauty and more.
JakeAl
I'm very interested in this vehicle. I have been watching it since it first appeared. The (non-vehicle related) content of the post seems to have changed a couple different times. I guess that's not a big deal but it does have me curious.
I am somewhat in the category of the "If only's" here, "if only this" "if only that". The reason being because I have a windfall of cash coming, hopefully in December, and I will have the means to make this sports car dream happen after decades of saying "if only".
My credit is good too but I'm unsure if I want to deal with another monthly bill.
I have been interested in 2 other cars here, The "Silver Devil" by ChrisWTX and Georges vert twin turbo.
I am way into having the power potential all these cars possess but will not likely use it that much. The question I am pondering is the amount I will have to be turning wrenches on these critters regularly if/when I make the move to purchase.
Regardless, we'll see how things look when "if only" time becomes "yah baby" time.
Loved the car James. It's a beauty and more.
JakeAl
11-22-2009, 08:36 PM
#17
Instructor
Member Since: Nov 2009
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
