*** HPE Flip-Drive Now $789 + FREE SHIPPING!!! For 2011***
#21
Intermediate
Member Since: Oct 2009
Location: Nashville TN
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Yep, Mario gave some feedback, but I would like you to answer my question. I an looking to purchase this product with a good answer from the manufacturer.
Is this system safe to take on long trips? It seems to me that running a 6-rib off of a 4 rib that is being taxed by the AC-Compressor would not last long at all. I have also seen where others have had problems. I am not trying to knock the product, but want to understand more why you think it is ok to run all of this off of that 4 rib belt.
#22
Pro
Thread Starter
You are more prone to failure from a single serpentine belt driven system, routing from the supercharger all the way around the accessories and back to the blower while cranking excessively down in an attempt to prevent belt slip.
Julian
#23
Drifting
Julio
#24
Race Director
#25
Pro
Thread Starter
Hey guys…thank you for the orders. I am almost at the tail end of the new list already. PM or call me if you want to be added for the remaining units left.
Julian Hormilla
(908) 317-4496
www.cartekracing.com
Julian Hormilla
(908) 317-4496
www.cartekracing.com
#30
Team Owner
#31
Team Owner
#33
Pro
Thread Starter
#34
Team Owner
#35
Drifting
#36
It seems a very nice kit!
I really want to see some customer's review about this kit especially anyone who had a belt slippage issue and after installing this kit he had 0 slippage now!
If this is the case,, I will be in the queue to get this kit soon
(currently I have A&A 8-rip setup)
I really want to see some customer's review about this kit especially anyone who had a belt slippage issue and after installing this kit he had 0 slippage now!
If this is the case,, I will be in the queue to get this kit soon
(currently I have A&A 8-rip setup)
#37
I ordered my kit today. I have a A&A 8 rib setup with a YSI and supporting mods. With a 10% overdriven crank and 3.00" pulley I am seeing about 13#s of boost and make 850rwhp. I am hoping to pick up a solid 2#s with no other changes and close in on the 900rwhp mark.
#38
Pro
Thread Starter
Julian
#39
Julian,
I forgot to ask. But I already upgraded to a complete 8 rib setup on my z. I assumed that the 8 rib pulleys will be ok with the flip drive. Just thought I would run the 6 rib belt and just have the extra 2 ribs on the accessory pulleys. Please confirm that this should work fine?
Thanks
I forgot to ask. But I already upgraded to a complete 8 rib setup on my z. I assumed that the 8 rib pulleys will be ok with the flip drive. Just thought I would run the 6 rib belt and just have the extra 2 ribs on the accessory pulleys. Please confirm that this should work fine?
Thanks