Procharger P1SC-1 Questions + Dallas Performance Intake
#1
Racer
Thread Starter
Member Since: Apr 2004
Location: AR
Posts: 293
Likes: 0
Received 0 Likes
on
0 Posts
Procharger P1SC-1 + Dallas Performance Intake
Is anyone running the Dallas Performance big mouth intake on a P1SC? I see lots of posts about running them on the F or D series Prochargers, but nothing on the P1SC. Would it be worthwhile to use it on the P1SC?
Last edited by flyinrazrback; 04-12-2015 at 04:01 PM.
#3
I'm running one. Not quite the same thing but close enough. I used their DP filter because they sell it separately and used a 4" angled pipe just like they do. Cost me $120 vice the $300 they want. Blower is P1SC-1. It will help on any blower and is not limited to the larger sized ones. No tune for it yet though so I do not know power gains. I am expecting 30-40 rwhp from it.
No it does not require a shortened aftermarket radiator like the Dewitts. You will have to do some massaging to the stock radiator for clearance though. I used a wood block and gently worked it down evenly. I trimmed the plastic shroud fan behind the radiator as well.
No it does not require a shortened aftermarket radiator like the Dewitts. You will have to do some massaging to the stock radiator for clearance though. I used a wood block and gently worked it down evenly. I trimmed the plastic shroud fan behind the radiator as well.
Last edited by djfury05; 04-12-2015 at 06:51 PM.
#4
Safety Car
Using one on a stock radiator.
#7
Safety Car
#8
Racer
Thread Starter
Member Since: Apr 2004
Location: AR
Posts: 293
Likes: 0
Received 0 Likes
on
0 Posts
Are you all running a boost a pump with your setup? My setup currently is making 560rwhp with no BAP but thinking of installing one when I add the Big Mouth. Might do a meth kit at the same time too.
#9
Safety Car
I ran on longer than I wanted to. Run a alky meth kit and love it. The Bap is coming off in favor of the Fore Innovations kit.
#12
Yes I've seen where you have to bend the top "fins" on the radiator down and massage it a bit. Also what would be the gains with the big mouth be on a stock ls2 c6 with the procharger kit on 7lbs over the stock procharger air inlet.
#14
That would be great! I sent them an email and he said the only problem would be if I have one of the older kits without the cradle drop and I think mine might be an older one. In that case I have to figure out a way to make it work I guess.
#15
Drifting
Wasn't even aware they made older kits without a cradle drop. Wonder how they got any intake on there at all. My kit was bought in 09 and is a base P1 kit with the cradle drop if that helps.
#16
Yea I actually would think mine has the drop. I'm going to call procharger this week with my procharger serial # and see if they can tell me when the kit was made. Hoping to gain around 50rwhp with the big mouth intake, headers, and a good tune.