Redline Motorsports

Finally after some ups and downs we where able to put a 7 second slip in the glove box. Didn't think it was going to happen last night as the track 20 feet out was crap. We had to back off quite a bit of power below the 330 so we feel a 7.6x is in striking range.... onward we go....check out the vid!

gotjuice?

Congradulations on the 7's, Nice run.

c5wolf

Damn you made it look easy,

Arctic Vette

Beast mode...

WHITE_SHARK

That's fast!! what kind of TT kit on there? front mount?

dascorcha21

how much boost are you launching at and what rpm? what was the total boost used on that pass?

b16gsr

very nice

Redline Motorsports

That pass was on launch boost at 6 psig around 4000 on the two step. Full pressure was 22 psig.

On a better prepped track; .6 seconds into the run we have been at 16 psig but this pass we down at 10 which is all it could take. I have no doubt we can 60' this thing close to 1.18.

As far as "kit" its APS cast manifolds and the rest is all custom.

HT

dascorcha21

awesome! im guessing you're managing the curve via time and g-force? what compression are you running?

sorry for all the questions we just have somewhat the same setup.

Redline Motorsports

Running an AMS-2000 trigger off the trans brake. Referenced by time. then we do a boost offset by RPM to final trim in the boost curve. We use G Force logging to determine where we can take more power which is also tied into wheel spin.....we are pushing the AMS for all its got.. bad *** controller.

The engine is 9.7:1

HT

C Moe

Hot damn! had to let the front page know!
https://www.corvetteforum.com/articl...ks-7s-14-mile/

WHITE_SHARK

How much whp on this pass? Any specs on the build and turbos used?
Hope you can break into mid of 7s soon!

Z06Gooz

Congrats Redline and Howard !!! Glad I was standing in the pit to see this live

Jalopy Bob

Congrats on the 7's! Is it running a powerglide? I know that time range finds glides in cars you would not expect to find one in.