236 MPH 1/2 mile. corvette and Rwd record
#1
236 MPH 1/2 mile. corvette and Rwd record
clicked off a 236.1 mph half mile pass at this most recent Shifts3ctor/Neverlift half mile event. reset the corvette and the RWD halfmile record. been chasing this one for awhile with this build and finally snagged it. same set up the car has been since last season, just getting it really dialed in finally. shooting for upper 240's 250s at the up coming shifts3ctor event at pikes peak CO. Few pics from the event below.
Speedhunters write up on the weekend out aswell
http://www.speedhunters.com/2018/05/...s-c6-corvette/
Speedhunters write up on the weekend out aswell
http://www.speedhunters.com/2018/05/...s-c6-corvette/
Last edited by ace32x; 05-12-2018 at 05:40 PM.
The following 2 users liked this post by ace32x:
rajahhindi (05-08-2018),
yur2slo (05-10-2018)
#7
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes
on
1,052 Posts
St. Jude Donor '15
Insane
#8
Le Mans Master
Member Since: Mar 2018
Location: The GREAT STATE of IOWA!
Posts: 7,075
Received 1,038 Likes
on
400 Posts
Congratulations on a job very well done. How is the down force on your front end handled? Are you using exhaust gas pressure instead of a splitter?
Last edited by Mcrider; 05-09-2018 at 08:08 PM.
#9
The following users liked this post:
schpenxel (05-10-2018)
#11
That thing is hauling serious ***. What’s the rear wheel setup? Those frickin tires are HUGE. How did you get those to fit? Mini tubs?
#13
Team Owner
#14
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,193 Likes
on
1,052 Posts
St. Jude Donor '15
Just crazy
#17
Its a 15x10 Weld RTS in standard c6 z06 fitment. The 325 50 15 Street R fit no problem on the stock fenderwells and fenders. but the 315 60 15 Pro's rubbed very badly, so over this winter i snagged the vengeance racing tubs and 1.5" supervettes rear fenders from Ron to better clearance the 315 pro's
The following 2 users liked this post by ace32x:
CI GS (05-10-2018),
Daniel@Vengeance (05-11-2018)
#18
The following users liked this post:
rajahhindi (05-23-2018)