Hood won't close after 2200r install
07-11-2018, 11:13 PM
#1
Burning Brakes
Thread Starter
Hood won't close after 2200r install
I've had the good off of the car for about a year while I installed a built motor and swapped out my 2200 HD for a new 2200r. I also installed new stock motor mounts. Buttoning up today, the passenger side of the hood doesn't stay shut unless I deliberately press down on the corner. It will stay shut, but there is a noticeable gap on the passenger side where the blower is. Has anyone had this issue? Do I need a spacer on the cradle? Hopefully, I'm not the only one that has had this.
07-11-2018, 11:49 PM
#2
Drifting
I've had the good off of the car for about a year while I installed a built motor and swapped out my 2200 HD for a new 2200r. I also installed new stock motor mounts. Buttoning up today, the passenger side of the hood doesn't stay shut unless I deliberately press down on the corner. It will stay shut, but there is a noticeable gap on the passenger side where the blower is. Has anyone had this issue? Do I need a spacer on the cradle? Hopefully, I'm not the only one that has had this.
07-12-2018, 10:04 AM
#4
Premium Supporting Vendor
Member Since: Oct 2004
Location: Providing the most proven supercharger kits for your C5/6/7 609-752-0321
Posts: 23,316
Received 1,085 Likes
on
656 Posts
Do you have an aftermarket hood? Normally that is not an issue. (assuming you're using our brackets)