FS - Z06 Dual mode NPP mufflers.. $500
12-20-2007, 10:34 AM
#1
Racer
Thread Starter
FS - Z06 Dual mode NPP mufflers.. $500
Payment received...Mufflers are sold....thanks everyone for your interest!
These are the factory OEM dual mode Z06 mufflers that I planned to install in our 07 coupe...which we replaced with an 08 Z06 so I won't need them anymore.
These are being offered for sale for only $500. New NPP mufflers are about $1200 new as I recall so you can save a ton of money!! I would prefer local pickup but will ship if you pay the shipping costs. Mufflers are as new (well 1000 miles) and tips are prefect.
The mufflers came off an '07 Z06 with less than 1000 miles and have the complete inlet pipe attached....the pipes were not cut off to make the muffler removal easier as most seem to do. They bolt on to any C6Z of course.
To fit these to a regular C6 you have two options;
1. Have a good muffler shop modify the inlet pipe down to 2.5 inch to fit the stock LS2 intermediate pipe, a very simple operation for a good muffler shop as the inlet pipe necks down to 2.5 inch as it enters the muffler housing.
2. If you are installing long tube headers at the same time you simply order a Z06 3 inch X-pipe instead of the 2.5 LS2 X pipe.
To make the valve operate you can purchase the GM parts, or from a forum vendor the "NPP in a box" and you are all set. Do a search and you will find lots of threads on how to connect the system up.
I can tell you from driving an '08 with NPP and our new C6Z this exhaust is the hot setup....quiet when you want is so, and pretty sporty when the valves open! In addition you upgrade from those little 3.5 in LS2 tips to proper size 4 inch Z06/ NPP tips...looks way better to me!
Will post pictures a little later.
Please PM me if your are interested!
Thanks,
James
These are the factory OEM dual mode Z06 mufflers that I planned to install in our 07 coupe...which we replaced with an 08 Z06 so I won't need them anymore.
These are being offered for sale for only $500. New NPP mufflers are about $1200 new as I recall so you can save a ton of money!! I would prefer local pickup but will ship if you pay the shipping costs. Mufflers are as new (well 1000 miles) and tips are prefect.
The mufflers came off an '07 Z06 with less than 1000 miles and have the complete inlet pipe attached....the pipes were not cut off to make the muffler removal easier as most seem to do. They bolt on to any C6Z of course.
To fit these to a regular C6 you have two options;
1. Have a good muffler shop modify the inlet pipe down to 2.5 inch to fit the stock LS2 intermediate pipe, a very simple operation for a good muffler shop as the inlet pipe necks down to 2.5 inch as it enters the muffler housing.
2. If you are installing long tube headers at the same time you simply order a Z06 3 inch X-pipe instead of the 2.5 LS2 X pipe.
To make the valve operate you can purchase the GM parts, or from a forum vendor the "NPP in a box" and you are all set. Do a search and you will find lots of threads on how to connect the system up.
I can tell you from driving an '08 with NPP and our new C6Z this exhaust is the hot setup....quiet when you want is so, and pretty sporty when the valves open! In addition you upgrade from those little 3.5 in LS2 tips to proper size 4 inch Z06/ NPP tips...looks way better to me!
Will post pictures a little later.
Please PM me if your are interested!
Thanks,
James
Last edited by High 11s; 12-22-2007 at 08:22 AM.
12-20-2007, 12:30 PM
#4
Racer
Thread Starter
Thanks Joe!
BTW ....Here is one method to hook to make the butterfly valves operational without running all the vacuum lines. Other forum vendors may offer similar setups. Cost I think was $225.
http://forums.corvetteforum.com/show...t=NPP+in+a+box
This was how I had planned to do it.....there are lots of other options.
Thanks..James
12-20-2007, 03:47 PM
#6
Racer
Thread Starter
12-20-2007, 04:17 PM
#8
Racer
Thread Starter
Did not receive your e-mail yet.....can you please re-send it ...thanks
Yes, still available but have some interested parties...no money sent yet!!
I have not measured or weighed them yet, but I will guess at $120 for shipping to you. If its more I will pay it, if its less, I will refund the difference to you.
Not even sure where to find a box for them yet....
Thanks for your interest....James
Yes, still available but have some interested parties...no money sent yet!!
I have not measured or weighed them yet, but I will guess at $120 for shipping to you. If its more I will pay it, if its less, I will refund the difference to you.
Not even sure where to find a box for them yet....
Thanks for your interest....James
Last edited by High 11s; 12-20-2007 at 04:24 PM.
12-20-2007, 07:19 PM
#9
Le Mans Master
Member Since: Apr 2001
Location: Ex-SF Bay Area; now happily Denver area
Posts: 8,133
Received 144 Likes
on
93 Posts
Did not receive your e-mail yet.....can you please re-send it ...thanks
Yes, still available but have some interested parties...no money sent yet!!
I have not measured or weighed them yet, but I will guess at $120 for shipping to you. If its more I will pay it, if its less, I will refund the difference to you.
Not even sure where to find a box for them yet....
Thanks for your interest....James
Yes, still available but have some interested parties...no money sent yet!!
I have not measured or weighed them yet, but I will guess at $120 for shipping to you. If its more I will pay it, if its less, I will refund the difference to you.
Not even sure where to find a box for them yet....
Thanks for your interest....James
Email sent again as well as PM.
12-20-2007, 11:37 PM
#11
Race Director
Member Since: Jan 2005
Location: Bay Shore, NY 11706 MILD2WILD (M2W)
Posts: 13,656
Likes: 0
Received 7 Likes
on
5 Posts
St. Jude Donor '06-'07
If you need a vacuum control mine has been ready and shipping for weeks.
http://forums.corvetteforum.com/show....php?t=1855461
It's actualy the one chosen by B&B to run their new systems
http://forums.corvetteforum.com/show....php?t=1855461
It's actualy the one chosen by B&B to run their new systems
12-21-2007, 08:03 AM
#13
Racer
Thread Starter
12-22-2007, 08:21 AM
#14
Racer
Thread Starter
If you need a vacuum control mine has been ready and shipping for weeks.
http://forums.corvetteforum.com/show....php?t=1855461
It's actualy the one chosen by B&B to run their new systems
http://forums.corvetteforum.com/show....php?t=1855461
It's actualy the one chosen by B&B to run their new systems
Payment received, mufflers are sold!
Ed, thanks for your post and congrats on now being a forum sponsor, I will pass on this info to my buyer. He will be needing your kit! Somehow I missed the fact that your kit was already in production!
James