F/S: C6 Z06 Oil Cooler and lines - NEW
#1
Melting Slicks
Thread Starter
F/S: C6 Z06 Oil Cooler and lines - NEW
SOLD! This is a NEW Z06 Oil Cooler and oil lines. Upgrade your existing Z51 oil cooler with this Z06 cooler or add one to your existing LS2/LS3. $400.00 + shipping. Christmas is just around the corner and this would make a great gift.
Last edited by Vettlldo; 11-28-2011 at 05:41 PM. Reason: Lowered price.
#3
Melting Slicks
Thread Starter
#4
Le Mans Master
#5
Melting Slicks
Thread Starter
Ok, then your LS2 should already have the embossed oil port for the oil lines on the driver side of the block. The only next question is whether or not the radiator shroud will accept the oil cooler mounting - I would say yes.
#8
Melting Slicks
Thread Starter
#9
Former Vendor
Member Since: Feb 2004
Location: Las Vegas NV
Posts: 10,876
Likes: 0
Received 8 Likes
on
7 Posts
St. Jude Donor '06 & '12
It should fit with no problem. While the line itself will work perfectly, there is no port for the oil temp sensor. So you will have to drill/tap for that. Or, you can run it like the C6's do.
Other than that, with a tad of tweaking, it will fit just fine.
Other than that, with a tad of tweaking, it will fit just fine.
#13
Melting Slicks
Thread Starter
#15
Safety Car
Member Since: Aug 2006
Location: Apache Junction AZ
Posts: 4,347
Likes: 0
Received 22 Likes
on
18 Posts
I have a '07 Z51 with, I believe, the oil cooler as part of the radiator and also have the APS TT intercoolers in front of the radiator. Does anyone know how I would go about this upgrade?
BJK
BJK
#16
Melting Slicks
Wont work! I had the same problem with my old Supercharged Vette.The Z06 oil cooler is located at the same location as your intercooler.
#17
Safety Car
Member Since: Aug 2006
Location: Apache Junction AZ
Posts: 4,347
Likes: 0
Received 22 Likes
on
18 Posts
http://www.airpowersystems.com/corve.../front_low.jpg
http://www.airpowersystems.com/corve...cooler/top.gif
Something like this may work.
BJK
#18
Melting Slicks
That's what I thought, but I am taking a second look at the APS oil cooler that they used in their Z06 kit.
http://www.airpowersystems.com/corve.../front_low.jpg
http://www.airpowersystems.com/corve...cooler/top.gif
Something like this may work.
BJK
http://www.airpowersystems.com/corve.../front_low.jpg
http://www.airpowersystems.com/corve...cooler/top.gif
Something like this may work.
BJK
#20
Melting Slicks
Thread Starter
The only purpose of this cooler is to lower engine oil temps since there is more fin surface area. The Z51 external oil cooler (2008-2011) is about 1/3 the size of the Z06 oil cooler. I don't see how it would harm any LS2/LS3 by lowering engine oil temperatures.