LME built LSX 427
11-06-2015, 03:05 PM
#1
Racer
Thread Starter
Member Since: Jun 2013
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
LME built LSX 427
Sold!!!!
!!I have a LSX engine for sale no miles short block was built by LME and i have all the specs i did the upper end install here is what i have:
LSX block 427 CI 9.7:1 Callie's dragonslayer crank, Callie's Ultra H-beam rods, wiseco pistons,SS rings,cam motion custom cam,mellings hv/hp ported pump,morel high rpm link bar lifters,Manton 3/8" pushrods,billet valley plate,Mast ls7 305 heads with hollow SS intake solid exhaust valves, Manley nextec springs with TI retainers, cometic head gaskets,billet double roller timing chain,sheetmetal custom oil pan, T&D shaft rockers, billet valve covers ,Arp studs and bolts everywhere. $12.5k I have well over $15K in it.
Intake not included but can be for a addition cost
I will separate the heads if I have a buyer for both heads and short block!
!!I have a LSX engine for sale no miles short block was built by LME and i have all the specs i did the upper end install here is what i have:
LSX block 427 CI 9.7:1 Callie's dragonslayer crank, Callie's Ultra H-beam rods, wiseco pistons,SS rings,cam motion custom cam,mellings hv/hp ported pump,morel high rpm link bar lifters,Manton 3/8" pushrods,billet valley plate,Mast ls7 305 heads with hollow SS intake solid exhaust valves, Manley nextec springs with TI retainers, cometic head gaskets,billet double roller timing chain,sheetmetal custom oil pan, T&D shaft rockers, billet valve covers ,Arp studs and bolts everywhere. $12.5k I have well over $15K in it.
Intake not included but can be for a addition cost
I will separate the heads if I have a buyer for both heads and short block!
Last edited by Realfast86; 12-01-2015 at 11:37 PM.
11-06-2015, 07:06 PM
#8
Racer
Thread Starter
Member Since: Jun 2013
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Its for sale also it's a Precision Metalcraft and there is a seperate listing for it! Very sweet intake lots of eye candy!
Last edited by Realfast86; 11-06-2015 at 07:08 PM.
