LS7 crank (wet or dry sump snout), LS7 Ti rods rebushed
#1
Burning Brakes
Thread Starter
LS7 crank (dry sump snout), LS7 Ti rods rebushed
Stock polished and cut .010/.010" LS7 crank $450 (this is less than the thickness of a horse hair)
LS7 Ti rods rebushed with Katech bushings, ARP rod bolts ready to go $1200
* I will only sell these as a combo. Meaning if you want the rods you need to buy the crankshaft and vice versa. It is too costly to try to rebalance the LS7 cranks and not run the Ti rods due to the costly Mallory needed to be added to the crank.
Shipping is additional. The crank is heavy and my guess is about $60 from CA to the midwest (CO/TX areas) and $80 to anywhere East of there. Rods I will pay for shipping to the lower 48.
LS7 Ti rods rebushed with Katech bushings, ARP rod bolts ready to go $1200
* I will only sell these as a combo. Meaning if you want the rods you need to buy the crankshaft and vice versa. It is too costly to try to rebalance the LS7 cranks and not run the Ti rods due to the costly Mallory needed to be added to the crank.
Shipping is additional. The crank is heavy and my guess is about $60 from CA to the midwest (CO/TX areas) and $80 to anywhere East of there. Rods I will pay for shipping to the lower 48.
Last edited by gnx7; 08-25-2017 at 04:14 PM.
#2
Burning Brakes
Thread Starter
to the top.... you can install these parts in an LS3 as well for a bad *** 416!
Add some Dart ProV1 LS3 heads (370cfm) and you could easily make 625hp+
Add some Dart ProV1 LS3 heads (370cfm) and you could easily make 625hp+
Last edited by gnx7; 12-29-2016 at 03:44 AM.
#7
Burning Brakes
How may miles on the reworked rods? Any pics?
#8
Burning Brakes
Thread Starter
I will take some pics of the rods today. They were supposedly from an engine with under 40K miles. Zero miles since being rebushed and fitted for ARP 2000 rod bolts.
As stated I will only sell a set of rods with the purchase of a crankshaft.
As stated I will only sell a set of rods with the purchase of a crankshaft.
#9
Instructor
I am only interested in the rods,so if you get someone who wants the crankshafts LMK. I would need good pictures of all of the rods,if we get that far. Thank you,Kevin