FS: Bay area: Ls7 bare block, C6Z manifolds & cats, Ls7 intake
#1
Bay area: Ls7 bare block, C6Z manifolds & cats, Ls7 intake
Hey guys, I was doing a build for my RX-7 and decided to go another route with the E-ROD LS3 to avoid headaches.
Manifold and cats - sold.
LS7 bare block with main caps, the deck was cut .030 and measures 9.210, two sleeves have cracks at the very top of the sleeve and run horizontal (Steve at R.E.D said this is common and should not be a problem but it still needs to be sleeved) small ding on the head surface but can be welded. I have a set of LS7 rods with wiseco pistons, they don't look good but they are free with the block - $200 obo - LOCAL PICK UP ONLY
LS7 Intake manifold with silver blade throttle body, fuel rail and injectors - $375 shipped
C6Z stock intake tube - $50 obo
Thanks
Manifold and cats - sold.
LS7 bare block with main caps, the deck was cut .030 and measures 9.210, two sleeves have cracks at the very top of the sleeve and run horizontal (Steve at R.E.D said this is common and should not be a problem but it still needs to be sleeved) small ding on the head surface but can be welded. I have a set of LS7 rods with wiseco pistons, they don't look good but they are free with the block - $200 obo - LOCAL PICK UP ONLY
LS7 Intake manifold with silver blade throttle body, fuel rail and injectors - $375 shipped
C6Z stock intake tube - $50 obo
Thanks
Last edited by ianlug; 02-18-2019 at 02:15 AM.
The following users liked this post:
GMGearJammer (02-11-2019)
#4
Ls7 block
Do you still have this block?
Hey guys, I was doing a build for my RX-7 and decided to go another route with the E-ROD LS3 to avoid headaches.
Manifold and cats - sold.
LS7 bare block with main caps, the deck was cut .030 and measures 9.210, two sleeves have cracks at the very top of the sleeve and run horizontal (Steve at R.E.D said this is common and should not be a problem but it still needs to be sleeved) small ding on the head surface but can be welded. I have a set of LS7 rods with wiseco pistons, they don't look good but they are free with the block - $200 obo - LOCAL PICK UP ONLY
LS7 Intake manifold with silver blade throttle body, fuel rail and injectors - $375 shipped
C6Z stock intake tube - $50 obo
Thanks
Manifold and cats - sold.
LS7 bare block with main caps, the deck was cut .030 and measures 9.210, two sleeves have cracks at the very top of the sleeve and run horizontal (Steve at R.E.D said this is common and should not be a problem but it still needs to be sleeved) small ding on the head surface but can be welded. I have a set of LS7 rods with wiseco pistons, they don't look good but they are free with the block - $200 obo - LOCAL PICK UP ONLY
LS7 Intake manifold with silver blade throttle body, fuel rail and injectors - $375 shipped
C6Z stock intake tube - $50 obo
Thanks