2007 z06 ecm location
#2
Team Owner
There are a few pics in Chuck's post here. Hope it helps. There might be better pics on his website.
http://forums.corvetteforum.com/c6-c...rder-tune.html
http://forums.corvetteforum.com/c6-c...rder-tune.html
#3
Former Vendor
Member Since: Nov 2005
Location: Ossining New York
Posts: 11,792
Received 243 Likes
on
183 Posts
St. Jude Donor '07-'08-'09-'10-'12-'13-'14
Thanks Pal!
There are a few pics in Chuck's post here. Hope it helps. There might be better pics on his website.
http://forums.corvetteforum.com/c6-c...rder-tune.html
http://forums.corvetteforum.com/c6-c...rder-tune.html
Chuck CoW
#4
Advanced
Member Since: Jan 2005
Location: Upstate New York
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
#5
Former Vendor
Member Since: Nov 2005
Location: Ossining New York
Posts: 11,792
Received 243 Likes
on
183 Posts
St. Jude Donor '07-'08-'09-'10-'12-'13-'14
The ZO6 is slightly....
The ZO6 is slightly different. If it's an 08 and earlier Z then the PCM is just behind the dry sump tank
and it's accessible just the same as the regular C6 from the same method but you just have to get in there
a bit further with your hands.
If it's ANY Corvette after 2009 then the pcm sits up high in the fender just above the opening in the fender well.
You access it just the same as the earlier C6 outlined in the above links, but you should have the vehicle
just a bit higher up off the ground to make it easier to reach up there.
Call me if you're stuck.
Chuck CoW