Wiring help needed: YAW/Lateral Acceleration Sensor
#1
Burning Brakes
Thread Starter
Wiring help needed: YAW/Lateral Acceleration Sensor
Can someone breakout a service manual and tell me what the 4 wires do that go into the sensor? I know, I need to buy a manual soon, looking for recommendations there too. TIA!
#2
Tech Contributor
Member Since: Dec 1999
Location: Anthony TX
Posts: 32,736
Received 2,180 Likes
on
1,583 Posts
CI 6,7,8,9,11 Vet
St. Jude Donor '08
I have SI at home and will break out that schematic for you later tonight. It will be for an 05 but, there shouldnt be any differences.
BC
#3
Instructor
Member Since: Feb 2011
Location: On a mountain New York
Posts: 235
Likes: 0
Received 0 Likes
on
0 Posts
Dark green is 5 volt reference. Next over is Light Blue which is low reference. Next over is Dark Blue which is yaw rate sensor signal and last is light green with black and it is lateral accelerometer signal. I cannot get up a pic until later.
Last edited by Luv2Fly; 05-22-2012 at 03:50 PM.
#5
Burning Brakes
Thread Starter
Dark Green, Dark Blue, Light Blue, Light Green with Black Stripe going left to right. I want to make sure I intercept the Yaw Rate sensor wire.
#7
Burning Brakes
Thread Starter
#13
Burning Brakes
Thread Starter
Ok.. one more cross reference, what is the wire color for an 07' C6Z06?
I'm trying to do what another racer here did:
http://forums.corvetteforum.com/1577118078-post54.html
I'm trying to defeat the computer in a race only C6 with no TPMS sensors in the wheels, and still be able to get all the Active Handling nannies OFF! So question is does an 07' C6Z06 have a yellow Yaw Rate Sensor Signal wire? Thanks for everyones time, this has been very helpful so far!!
http://forums.corvetteforum.com/1577118078-post54.html
I'm trying to defeat the computer in a race only C6 with no TPMS sensors in the wheels, and still be able to get all the Active Handling nannies OFF! So question is does an 07' C6Z06 have a yellow Yaw Rate Sensor Signal wire? Thanks for everyones time, this has been very helpful so far!!
#14
Melting Slicks
Member Since: Nov 2000
Location: Merritt Island Florida
Posts: 2,225
Received 241 Likes
on
145 Posts
I'm trying to do what another racer here did:
http://forums.corvetteforum.com/1577118078-post54.html
I'm trying to defeat the computer in a race only C6 with no TPMS sensors in the wheels, and still be able to get all the Active Handling nannies OFF! So question is does an 07' C6Z06 have a yellow Yaw Rate Sensor Signal wire? Thanks for everyones time, this has been very helpful so far!!
http://forums.corvetteforum.com/1577118078-post54.html
I'm trying to defeat the computer in a race only C6 with no TPMS sensors in the wheels, and still be able to get all the Active Handling nannies OFF! So question is does an 07' C6Z06 have a yellow Yaw Rate Sensor Signal wire? Thanks for everyones time, this has been very helpful so far!!
i also got the advice from SVCJMO, but i am not sure which wire to cut
Rune
Last edited by Z06Norway; 07-29-2012 at 04:51 PM. Reason: missed a sentence
#15
Melting Slicks
Member Since: Nov 2000
Location: Merritt Island Florida
Posts: 2,225
Received 241 Likes
on
145 Posts
i found my wire
it is not yellow, it is dark blue as indicated by a post further up. my connector looks identical, and i will try to cut the blue wire and see what will happen.
Or can i just unplug it and that will do the same trick ?
remember i want AH copletely removed and not go into limp mode or loose ABS
regards
Rune
Or can i just unplug it and that will do the same trick ?
remember i want AH copletely removed and not go into limp mode or loose ABS
regards
Rune