c6 corsa sport related question
#1
1st Gear
Thread Starter
Member Since: Jan 2018
Location: wilkes-barre pa
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
c6 corsa sport related question
I recently purchased a 2010 C6 base that came with the corsa sport exhaust (judging this by pictures on the manufacture website compared with my exhaust) I did some searching and can't find an answer to my situation. Most aftermarket LTH and X pipes come in at 3". Anyone have the dimensions for the corsa and would I be able to use a 3" X to connect to the corsa? If this has been answered, I apologize, I have been searching for days with no answers.
#3
Race Director
You need to have a reducer welded in place or better yet clamped. A 3 inch at on end and 2 1/2 in at the opposite end.
Do it before the axle over pipes at the end of the mid pipe.
Best way is clamped then it can be taken apart.
And the gas have cooled enough by the reducer that it means little or nothing powerwise, a non issue.
Do it before the axle over pipes at the end of the mid pipe.
Best way is clamped then it can be taken apart.
And the gas have cooled enough by the reducer that it means little or nothing powerwise, a non issue.
Last edited by Boomer111; 02-01-2018 at 05:30 PM.