Mishimoto Performance Radiator Thread
#81
-Nick
#83
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
Nick if you make one for an 02 1500 truck can you pm me a price please?
Local competitor is a little too proud of theirs . Everything hook up as factory>
Local competitor is a little too proud of theirs . Everything hook up as factory>
#84
Racer
I'm glad I found this thread today because I overheated at my last track day. But that was mostly due to spending 3 laps at redline, 1 cooldown lap later and I was fine.
#85
Racer
I know the questions are being beat to death but do you forsee any conflict with this radiator and the UPP twin turbo kit? I just ordered mine and their installation instructions mention notching the radiator for the charge pipe (I see this comes pre cut) and also installing a supplementary radiator bracket that angles the radiator in a little further to make room for their front mount intercooler. from the pictures I imagine it shouldn't be a problem but I didn't know if you saw any issue the increased angle in terms of airflow.
#86
I know the questions are being beat to death but do you forsee any conflict with this radiator and the UPP twin turbo kit? I just ordered mine and their installation instructions mention notching the radiator for the charge pipe (I see this comes pre cut) and also installing a supplementary radiator bracket that angles the radiator in a little further to make room for their front mount intercooler. from the pictures I imagine it shouldn't be a problem but I didn't know if you saw any issue the increased angle in terms of airflow.
To answer your question, though, yup we specifically included that cutout for the massive intakes (or charge pipes in your case) that are offered for the C6. From the looks of it, you should have no problems with fitting our rad in there with the turbo kit. It's not any taller than the stock design, which is what I noticed was in most of the installed photos I came across. Also, as long as the added angle isn't too drastic, I don't see that affecting it too much either. Granted, there is going to be some reduced airflow to the rad with the intercooler there, but our's should have no issue keeping up!
-Nick
#91
These aren't shipping just yet, but we're aiming to have these out the door by early September! I'll keep you guys in the loop if any of that changes!
Thanks,
Nick
Last edited by Mishimoto; 08-22-2018 at 08:56 AM.
#92
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
#97
Too bad this pre-sale isn't in Spring instead of Fall. I'd be much more likely to buy one with the summer heat on its way!
#98
-Nick