Kooks X Pipe Torque "ANXIETY" Plz Help
#1
Pro
Thread Starter
Kooks X Pipe Torque-Plz Help!
Kooks didn't supply me with torque specs for X pipe to collector. From GM shop manual its saying "Intermediate Pipe to Catalytic Converter Pipe Nut - 6.0L is 12 lb ft"
MY problem, is the collectors bolts are much tighter than that to get them to seal collector and X Pipe.
Afraid I am going to break a bolt.
Ideas for torque spec?
MY problem, is the collectors bolts are much tighter than that to get them to seal collector and X Pipe.
Afraid I am going to break a bolt.
Ideas for torque spec?
Last edited by rc51racer; 05-05-2019 at 04:17 PM.
The following users liked this post:
rc51racer (05-05-2019)
#3
Pro
Thread Starter
Thank you!
thats what I was proceeding with today.
thats what I was proceeding with today.
The following users liked this post:
rc51racer (05-11-2019)
The following users liked this post:
rc51racer (05-12-2019)
#6
Pro
Thread Starter
I used 25 lb ft. so far it sealed