c7 bartlett

Here's the numbers with V3 SI Trim, TSP long tube headers, 3.8 pulley and dyno tune

Truckdoctor

Nice numbers!

FlatPlaneCrankDreams

No meth?

c7 bartlett

No meth yet.

Iceman09

Catted or non-catted x-pipe? Do you know how much boost you're at with the 3.8? Nice numbers!

c7 bartlett

Non catted x-pipe i don't know how much boost.

robert miller

That looks really good man even more so without the meth. Get the meth just for the safety thing & the break out sensor for the car.

I am taking my A/A TI with the 3.6 pulley with s/nozzle spray to the tuner in 3 more weeks so just driving the car as G/mother at the moment. Robert

chefcg1

Looks good! Almost exact numbers I got 606whp, 566torque.

FYREANT

Running meth and dropping pulley to a 3.47" will get you close to where I am - 639HP/618TQ

LSX228R

Nice and simple setup.

Next mods would be meth/pulley down/cam

Onefst2004

Who sells the 3.47 pulley for the si

Patriot Six

Get some good tires and enjoy it.

FYREANT

They are available directly from A&A. For the 3.6" and 3.47" pulley you need to move down to a smaller belt. The "green" one.

Onefst2004

Is the TI head unit a lot better than the SI head unit. Just adding long tube headers afe air cat less , tune ,meth, and a cam. And what is a good price for a sI kit thanks for the help new be

Fast6.3

I have an appointment on May 15 with Cordes performance to install my AA Ti kit with 3.6 pulley meth tsp headers noncatted xpipe. Hopefully Ill get some good numbers
I cant wait

robert miller

Should be pushing 650 to 675 rwhp.

robert miller

No need for the afe air box you will have to cut it off at the end plus you get a new air filter, If you have not going the set up yet get the TI with a 3.6 pulley. With meth and this set up the car will be good to get all the rwhp to it with having to chg out & adding a 2nd add on fuel system.

Plus I think this is the max to this motor and really being safe on it also. That is without adding forged pistons & if you do that & cant do that yourself about 30 hrs labor & cost of pistons just this is like 5,k

c7 bartlett

Do i need meth with 607 rwhp?

Cordes Performance Racing

Will make good power, around 630-640. Don't get hung up on numbers, I don't believe the op numbers at all without meth, his high side is tanking fast and even on 93 I don't see it taking the timing correctly to hit that.

630ish

robert miller

It will be what it is Joe like you say that # is just a number. Just have to get use to the car & set up. C5 with a RHS 427 & F1X on it my best was 1.27 60 ft & 139 mph in the 1/8 mile. Plus the car was still pulling like a train. That is also with a 275x15 weld bead lock non dot tire on the rear.

This will be all I do to this set up other than when it goes I will put all good parts in a short block set up with maybe a small cam. I am over the almost 1300 rwhp on a daily driver. Just to much parts to break & upkeep on them. Robert