What did you do to your C7 today?
#201
Melting Slicks
Playboy, car is looking good. Can you tell me about the Stage 2 winglets. Were these the factory parts installed on a Z51 spoiler? And how did you get them to sit flush with the sides of the fenders? Other guys have tried this but they stick out because the Z06/GS rear is wider. Would love to try this option otherwise I am plunking down $1,100 for the APR carbon fiber unit. Tks, dovervold
#203
There is no need to buy an entire exhaust system just to have black tips.
Here is my NPP exhaust. A 3 hour job mainly had to wait between paint coats.
Never even took the exhaust off. Regards to painting, it's all about the prep. I have NEVER had any paint fade, dull or peel from exhaust tips. Exhaust tip temps on most cars typically go from 300F-500F at most.
Parts needed:
3M Scotch Pad $4
Black High Gloss High Temperature Spray Paint $6
Masking tape $4
Here is my NPP exhaust. A 3 hour job mainly had to wait between paint coats.
Never even took the exhaust off. Regards to painting, it's all about the prep. I have NEVER had any paint fade, dull or peel from exhaust tips. Exhaust tip temps on most cars typically go from 300F-500F at most.
Parts needed:
3M Scotch Pad $4
Black High Gloss High Temperature Spray Paint $6
Masking tape $4
Last edited by prince8619; 02-19-2017 at 03:30 PM.
The following 6 users liked this post by prince8619:
bosco1 (04-07-2019),
dakotagoon (01-29-2020),
radiant (11-16-2021),
SixGunOutlaw (03-20-2023),
snow (02-21-2017),
and 1 others liked this post.
#204
Playboy, car is looking good. Can you tell me about the Stage 2 winglets. Were these the factory parts installed on a Z51 spoiler? And how did you get them to sit flush with the sides of the fenders? Other guys have tried this but they stick out because the Z06/GS rear is wider. Would love to try this option otherwise I am plunking down $1,100 for the APR carbon fiber unit. Tks, dovervold
The following users liked this post:
Playboy2 (02-19-2017)
#207
Pro
Reset the tire pressure, polished the windshield with the 3" orbital buffer, applied Rain-X, polished the rest of the glass by hand, cleaned under the hood, used Dr. Color Chip on the LF fender, vacuumed the interior, wiped down the interior, cleaned a couple of dirty spots on the driver's side door panel, removed and cleaned the license plate and frame, painted a couple of screws for when I re-install, and took a nap (actually that was for me, not the car).
Tomorrow strip with Dawn, clay bar, and apply the Zaino.
Tomorrow strip with Dawn, clay bar, and apply the Zaino.
The following 2 users liked this post by Jcaroglani:
beaversstonehaven (02-21-2017),
Gravitas (08-24-2023)
#212
Melting Slicks
What did I do to my C7 today? I drove it in the rain!
I got it all nice and clean Friday and took it for a nice drive to get it dirty again. It cleared up and got sunny later so my passenger could enjoy having the window open!
So I not only drove it in the rain, I let my dog ride shotgun... That's what I did for my C7 today.
I got it all nice and clean Friday and took it for a nice drive to get it dirty again. It cleared up and got sunny later so my passenger could enjoy having the window open!
So I not only drove it in the rain, I let my dog ride shotgun... That's what I did for my C7 today.
The following 6 users liked this post by AaronZ51:
17Z (04-05-2017),
Birddog51 (10-25-2020),
KGS365 (02-19-2017),
koreanbeefcake (01-13-2019),
robert miller (02-20-2017),
and 1 others liked this post.
#213
Pro
Playboy, car is looking good. Can you tell me about the Stage 2 winglets. Were these the factory parts installed on a Z51 spoiler? And how did you get them to sit flush with the sides of the fenders? Other guys have tried this but they stick out because the Z06/GS rear is wider. Would love to try this option otherwise I am plunking down $1,100 for the APR carbon fiber unit. Tks, dovervold
The following 6 users liked this post by walker3:
360Lemans (02-20-2017),
owc6 (02-19-2017),
phatpipez (03-04-2018),
Powelltc1 (05-29-2019),
robert miller (02-20-2017),
and 1 others liked this post.
#218
Pro
What did I do to my C7 today? I drove it in the rain!
I got it all nice and clean Friday and took it for a nice drive to get it dirty again. It cleared up and got sunny later so my passenger could enjoy having the window open!
So I not only drove it in the rain, I let my dog ride shotgun... That's what I did for my C7 today.
I got it all nice and clean Friday and took it for a nice drive to get it dirty again. It cleared up and got sunny later so my passenger could enjoy having the window open!
So I not only drove it in the rain, I let my dog ride shotgun... That's what I did for my C7 today.
The following users liked this post:
AaronZ51 (02-23-2017)
#220
Le Mans Master
Installed a Z06 stage 1 "poverty" splitter in Carbon Flash on my '14 Z51:
The following users liked this post:
B177YB0B (02-21-2017)