When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Changed the oil using my new Quickjack yesterday today I am replacing my brake pads with dustless pads and if I get real ambitious I will change out the shifter for the short throw shifter I bought.
Jack
Working with a lift is so much easier. I have an Atlas Kwik Bay, a little more cumbersome, but I can park a car over it so it's always ready to go.
I thought about one of those but I like the portability and the ability to remove the lift I can set the car down on the wheel cribs and remove the jacks so I can work on the rockers.
I thought about one of those but I like the portability and the ability to remove the lift I can set the car down on the wheel cribs and remove the jacks so I can work on the rockers.
Jack
I made wodden blocks kinda like cribs so I can drop the car on it and lower the lift to the floor. This lift also has a locking system so I can leave it up whithout fear of it coming down over time.
^^^ Steve as always some very nice piece's on the car man. Need to get my car motor back up & running got me a new lower C.F. piece for the piece hoping this one will fit correct & going to use the lower tray also, Plus got a new taller z06 rear spoiler also to put onto the car.. But man your car looks great man.. Robert
ACS Stage 2 front splitter
ACS Rockers
ACS Mud guards and brake scoop covers
ACS Black side markers
ACS Rear diffusers
a Tow hook for good measure
and finally Crystal Serum Light topped with EXO
Found a hole in the HX, so installed a Weapon X HX, plus oil change and stage 2 front splitter. Next weekend will be side skirts. Hardest part of the job, pulling the front fascia The bastard of a rock that necessitated the HX replacement Front back on, almost ready to roll
The snow finally melted, the weather warmed enough to get the car out so drove over to a friend's and replaced,the stock brake pads with Carbotech ceramics and then installed some fenderwell extensions to keep the rocks coming off the front tire's of the GS to help eliminate rock chips. Today was a great day.
I finally got bored enough to install my GM stage 2 wicker bills.
looks good! I got mine yesterday and will get them installed tomorrow. Did you have a small ish gap on the insides near the break light when lining it up, looks like you gotta push it like 1/2” to get it flush? The screws hold this ok?...
03-17-2019, 08:58 AM
Robert
