gavinvr4

Thanks for stopping by, friend of mine has a 2014 stingray and was wondering if factory Z06 wheels can fit for that application.
Thanks

rsvette12

Nope - they are to wide - Z06 quarter panel are wider and fronts have same issue

rsvette12

There are aftermarket versions that look like them but correct sizes fyi

gavinvr4

Thanks for the quick reply.

rsvette12

Welcome - good luck

Patches

I'm running HRE 20x9.5 fronts and 21x12 rears with Pirelli Pzero 285/25/20 and 375/20/21. They were designed by HRE to fit the base C7.

Joe C5 C2

[QUOTE=Patches;1597465890]I'm running HRE 20x9.5 fronts and 21x12 rears with Pirelli Pzero 285/25/20 and 375/20/21. They were designed by HRE to fit the base C7.
QUOTE]
Very nice!

Billy346

Those are slick. HRE makes some nice rims. They're a little spendy, but worth it!

gavinvr4

Those HRE's are SWEET!!!! I would be scared to drive with them since they cost arm and a leg, not to mention chances of bending the wheels.

lakemg

Is it just the angle of the photo or is that rear wheel sticking out past the wheel well?

Patches

lakemg

Nice!!!

pbateman

I love my HRE's, but by careful using their recommended tire sizes. They were just flat out wrong in my case. My wheel sticks out past the rubber.

Foosh

Agree. I bought a set of HREs using their offset specs for my C6 Z06, and they looked like the pictures above extending slightly beyond the fender lip in the rear. That did cause tire contact with the fender lip at full suspension travel. Beware.