When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Wrapped my poverty splitter in Carbon Fiber wrap .....not bad job at all plus I will not break out into tears if I scrape it ...$8.00 bucks at Amazon ....
It was not as hard as I thought but I did have to use two pieces. I made sure to line up the weave at the seam so it matches perfect and you cant tell it's two pieces
AI am just happy that if I scrape it I dont have to hold a funeral
Dave
That really looks good! Looks like the real thing. Down there on the bottom like that you can't see the difference between it and the real thing. With splitters it isn't if you will damage them. It's when. (I know. Not in all cases.)
That really looks good! Looks like the real thing. Down there on the bottom like that you can't see the difference between it and the real thing. With splitters it isn't if you will damage them. It's when. (I know. Not in all cases.)
Exactly Joe , I could not bear the thought of spending a lot of money on a real carbon fiber splitter only to scrape or crush it ...
My C7 has carbon flash everywhere, no carbon fiber. I wanted to paint my poverty splitter carbon flash, but I figured with the amount of money and effort it would take to sand and paint to make it look respectable, I might as well buy the stage two splitter. Given my skill level, it still might look half assed after painting. I've blown enough money lately that I don't want to part with the funds right now.
The splitter above looks very nice. Any opinions welcome - would this look okay on a shark gray car with carbon flash accents everywhere (including wheels)? I'll eventually get the stage two splitter in carbon flash but this seems like a potential replacement until I reach that point.
My C7 has carbon flash everywhere, no carbon fiber. I wanted to paint my poverty splitter carbon flash, but I figured with the amount of money and effort it would take to sand and paint to make it look respectable, I might as well buy the stage two splitter. Given my skill level, it still might look half assed after painting. I've blown enough money lately that I don't want to part with the funds right now.
The splitter above looks very nice. Any opinions welcome - would this look okay on a shark gray car with carbon flash accents everywhere (including wheels)? I'll eventually get the stage two splitter in carbon flash but this seems like a potential replacement until I reach that point.
My car has carbon flash everywhere but I do have carbon fiber side skirts and like u I originally painted the splitter black but was not happy at all with the results ....I am not a painter lol
03-15-2019, 09:30 PM
And tonight's Cub Scout project is ..........
