FS: Tinted brake light covers, MT ET Streets/18" wheels, Katech ported TB, armrest, etc
#1
Tinted brake light covers, MT ET Streets/18" wheels, Katech ported TB, armrest, etc
Have the following parts remaining from my C7Z sale:
(Crossed out = sold)
1) Tinted/molded brake light covers - $180
*Small scuff on one of the covers (pictured); hard to see it when they're installed
2) Mickey Thompson ET Streets 345/35/18 with 18" repro C7Z wheels in black - $575
*Tires have around 5k street miles on them, pretty much right at the wear bars but would be great for drag use.
3) Katech ported LT4 throttle body - $215
4) Stop flop cup holder -$35
5) 2018 center armrest (black) -$110
6) OEM stage 1 rear winglets - $80
7) OEM LT4 harmonic balancer with belt - $80
(Crossed out = sold)
*Small scuff on one of the covers (pictured); hard to see it when they're installed
*Tires have around 5k street miles on them, pretty much right at the wear bars but would be great for drag use.
4) Stop flop cup holder -$35
5) 2018 center armrest (black) -$110
6) OEM stage 1 rear winglets - $80
7) OEM LT4 harmonic balancer with belt - $80
Last edited by zee11; 06-27-2019 at 04:54 PM.
#3
Pretty sure they 'fit' but yeah, they would stick out a little past the fender. This was pretty common to see in my C6 days, not sure about for C7s. If you were gonna use them for just a drag setup, I'm sure it would be fine.
Thanks!
Thanks!
#14
Melting Slicks
Tinted tail light covers....
I guess there's no way to get the scuff off the tinted tail light covers? Is the scuff on the covers in the picture of the rear of the car & which cover is it? I am sure the closeup picture of the scuff makes it appear larger than it actually is. Since you had these installed there is no longer 3m tape in place to secure them? What is your current price on these? Thanks.
#19