Cheaper route for 15" wheel conversion
#1
Cheaper route for 15" wheel conversion
has anyone gone or done a cheaper route
for the 15" rear wheel conversion ? l.g and carlysle mke kits but they are 4950 without the rims? Sorry but I don't see that justifiable cost just to run 15" rims.
this is what lg comes with
for the 15" rear wheel conversion ? l.g and carlysle mke kits but they are 4950 without the rims? Sorry but I don't see that justifiable cost just to run 15" rims.
this is what lg comes with
- LLG Motorsports C7 Billet Drag Spindles
- LG Motorsports Chrome Moly custom lower control arms
- LG Motorsports custom one piece rear brake rotors
LG Motorsports rear lowering boltsModified
GM single piston calipers in red
GM caliper brackets
rear brake pads and hardware
Two lower control arm bolts
Ball joints installed into spindles and control arms
All supporting hardware...
anyone done or recomend a cheaper route to run 15s...?
#2
Team Owner
Member Since: Jan 2007
Location: cookeville tennessee
Posts: 28,846
Received 1,762 Likes
on
1,529 Posts
has anyone gone or done a cheaper route
for the 15" rear wheel conversion ? l.g and carlysle mke kits but they are 4950 without the rims? Sorry but I don't see that justifiable cost just to run 15" rims.
this is what lg comes with
for the 15" rear wheel conversion ? l.g and carlysle mke kits but they are 4950 without the rims? Sorry but I don't see that justifiable cost just to run 15" rims.
this is what lg comes with
- LLG Motorsports C7 Billet Drag Spindles
- LG Motorsports Chrome Moly custom lower control arms
- LG Motorsports custom one piece rear brake rotors
LG Motorsports rear lowering boltsModified
GM single piston calipers in red
GM caliper brackets
rear brake pads and hardware
Two lower control arm bolts
Ball joints installed into spindles and control arms
All supporting hardware...
anyone done or recomend a cheaper route to run 15s...?
I put the LG stuff with 15 weld bead lock rims on my c5 but I still had to grind down that little hump in the middle of the caliber on the stock c5 piece. Robert
Plus one guy in the c5 he had the c5 stock spindle cut down then had it welded back up also had a small piece welded on the back side where it was cut and welded also welded onto that making it more stronger. I really don't know if I would do that but he was still racing it on his c5 and the 15 inch rims fit his car. Robert
Last edited by robert miller; 03-05-2017 at 01:01 PM.