Katech CNC porting to your LT1 heads. Killer pricing.
#1
Premium Supporting Vendor
Thread Starter
Katech CNC porting to your LT1 heads. Killer pricing.
We are now offering CNC porting of LT1 heads as a service if you send in yours. We've also come up with an extremely competitive price on this. Just send in your bare, clean heads and we'll CNC port them for only $499. If you would like us to disassemble, wash and assemble to either stock spec or Katech package specs, just add those items to your cart. Turnaround time is expected to be just a few days but could vary based on shop load.
To order, use the link below:
http://store.katechengines.com/cnc-p...eads-p578.aspx
To order, use the link below:
http://store.katechengines.com/cnc-p...eads-p578.aspx
Last edited by Katech_Zach; 07-24-2017 at 01:35 PM.
#2
Le Mans Master
Do you have any lower lift before and after flowbench numbers? I found these, but my cam spends no time at .700, so curious what the gains were like around .300
"New Katech CNC ported LT1 cylinder heads flow 332cfm on the intake and 239cfm on the exhaust compared to the stock 295cfm intake and 221cfm exhaust at .700 lift."
Do you have a similar program for the LT4 heads?
"New Katech CNC ported LT1 cylinder heads flow 332cfm on the intake and 239cfm on the exhaust compared to the stock 295cfm intake and 221cfm exhaust at .700 lift."
Do you have a similar program for the LT4 heads?
Last edited by davepl; 07-28-2017 at 01:28 PM.
#3
Premium Supporting Vendor
Thread Starter
Do you have any lower lift before and after flowbench numbers? I found these, but my cam spends no time at .700, so curious what the gains were like around .300
"New Katech CNC ported LT1 cylinder heads flow 332cfm on the intake and 239cfm on the exhaust compared to the stock 295cfm intake and 221cfm exhaust at .700 lift."
Do you have a similar program for the LT4 heads?
"New Katech CNC ported LT1 cylinder heads flow 332cfm on the intake and 239cfm on the exhaust compared to the stock 295cfm intake and 221cfm exhaust at .700 lift."
Do you have a similar program for the LT4 heads?
Yes, we run the same program on the LT4.
#6
Premium Supporting Vendor
Thread Starter