Torque tube anyone
#1
Racer
Thread Starter
Torque tube anyone
I posted on C7 general forum, maybe the wrong place, I'll try here.
I understand there is an inspection port at front of torque tube. How much can actually be analyzed like bearing, coupler, flex plate, etc., thru that opening? Thanks for any comments, Jim
I understand there is an inspection port at front of torque tube. How much can actually be analyzed like bearing, coupler, flex plate, etc., thru that opening? Thanks for any comments, Jim
The following users liked this post:
CorvetteMike2024 (05-09-2022)
#4
Instructor
To inspect, remove the rubber cap on the bell housing. Use your phone or borescope inspection camera. If the drive shaft bearing is recessed more than a 1/4 inch in the torque tube then it's bad.
I just finished replacing my torque tube and converter using a quick jack and a couple of harbor freight transmission jacks.
I just finished replacing my torque tube and converter using a quick jack and a couple of harbor freight transmission jacks.
The following 2 users liked this post by djyankees31:
CorvetteMike2024 (05-12-2022),
GeoGS (05-12-2022)