Header guys, check this wire for signs of melting
#1
Header guys, check this wire for signs of melting
I’ve only been running headers for a few hundred miles and today I noticed this on the passenger side:
It has only only melted the outer plastic insulation exposing a beefy wire underneath. Whether or not the heat would start melting the wire inside I don’t know, but I’m going to make a point of wrapping it in reflective tape.
It has only only melted the outer plastic insulation exposing a beefy wire underneath. Whether or not the heat would start melting the wire inside I don’t know, but I’m going to make a point of wrapping it in reflective tape.
#3
Le Mans Master
Member Since: Aug 2001
Location: Savannah GA
Posts: 6,070
Received 280 Likes
on
213 Posts
Cruise-In IV Veteran
You can see where I used it on my Holley wires in the below pic which run by my Kooks headers and down my tunnel. It has held up perfectly for months now. Even tracking at Roebling Road Raceway for 20 min hard sessions.