Now available from SCP: C7 Corvette Brey Krause Harness Bar
#1
Supporting Vendor
Thread Starter
Member Since: Jun 2005
Location: Marietta Georgia
Posts: 20,644
Received 315 Likes
on
288 Posts
St. Jude Donor '06-'07, '13, '15
Now available from SCP: C7 Corvette Brey Krause Harness Bar
C7 Corvette Brey Krause Harness Bar
The C7 harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. Our bars are easy to install and remove, use only existing holes and mounting points.
Material: Type 304, stainless steel.
Finish: Powder-coated in durable black wrinkle-finish Weight: 17.12 lbs.
Models: C7 Coupes and Z06 Coupes
Installation: Bar attaches to factory mounting points in "B" pillars.
Application:
2014 C7 Corvette Stingray Coupe
2015 C7 Corvette Stingray Coupe
2016 C7 Corvette Stingray Coupe
2015 C7 Z06 Corvette
2016 C7 Z06 Corvette
Note: Because of mounting locations in the C7, the b-pillar plastic sail panel covers will require slot on either side to be cut. Sail panels replacements can be ordered from your GM Dealer, part 23176134 for driver side, and part 23176135 for passenger side if you do not want to cut the original panels. Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts.
Check it out here: C7 Corvette Brey Krause Harness Bar
The C7 harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. Our bars are easy to install and remove, use only existing holes and mounting points.
Material: Type 304, stainless steel.
Finish: Powder-coated in durable black wrinkle-finish Weight: 17.12 lbs.
Models: C7 Coupes and Z06 Coupes
Installation: Bar attaches to factory mounting points in "B" pillars.
Application:
2014 C7 Corvette Stingray Coupe
2015 C7 Corvette Stingray Coupe
2016 C7 Corvette Stingray Coupe
2015 C7 Z06 Corvette
2016 C7 Z06 Corvette
Note: Because of mounting locations in the C7, the b-pillar plastic sail panel covers will require slot on either side to be cut. Sail panels replacements can be ordered from your GM Dealer, part 23176134 for driver side, and part 23176135 for passenger side if you do not want to cut the original panels. Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts.
Check it out here: C7 Corvette Brey Krause Harness Bar
__________________
Last edited by southerncarparts; 11-10-2017 at 10:09 AM.