C7 Z06 Discussion General Z06 Corvette Discussion, LT4 Corvette Technical Info, Performance Upgrades, Suspension Setup for Street or Track
Sponsored by:
Sponsored by: GEM Motorsports

Which setting is best for launch control? Sport 2 caused too much spinning

Thread Tools
 
Search this Thread
 
Old 03-21-2018, 06:36 PM
  #1  
Zo62018A8
Melting Slicks
Thread Starter
 
Zo62018A8's Avatar
 
Member Since: Aug 2011
Location: Ft Lauderdale, Florida
Posts: 3,034
Received 361 Likes on 216 Posts

Default Which setting is best for launch control? Sport 2 caused too much spinning

I was looking at the various launch control for automatic c7 z06 models on youtube and It seems like sport 2 is preferred. I tried it yesterday like instructed and when I initially dumped the brake it started off fine then just started spinning too much (I think soon as it went into second gear). Was it wrong for me to stay on the throttle all the way down after releasing the brake because I was trying to get the best 0-60 time? I didnt try the other settings (wet, dry, race, etc) yet.
Old 03-21-2018, 07:02 PM
  #2  
Zo62018A8
Melting Slicks
Thread Starter
 
Zo62018A8's Avatar
 
Member Since: Aug 2011
Location: Ft Lauderdale, Florida
Posts: 3,034
Received 361 Likes on 216 Posts

Default

Car is completely stock. What is the difference between sport 1 and 2 during launch control? The excess tire spin didnt happen until the car went into second gear I believe. Next time I will use the PDR to record what Im doing.
Old 03-21-2018, 08:34 PM
  #3  
123sugey
Dig
Support Corvetteforum!
 
123sugey's Avatar
 
Member Since: Jan 2006
Location: Port Saint Lucie FLORIDA & HONDURAS
Posts: 4,801
Received 759 Likes on 515 Posts

Default

If you launched without spinning .... especially after “power braking it” off the line..... the track wasn’t prepped well near or after the 60’. Test & tune nights aren’t the best for your best ET never mind 60’
Old 03-21-2018, 09:01 PM
  #4  
123sugey
Dig
Support Corvetteforum!
 
123sugey's Avatar
 
Member Since: Jan 2006
Location: Port Saint Lucie FLORIDA & HONDURAS
Posts: 4,801
Received 759 Likes on 515 Posts

Default

On a side note the car could have started to spin on the top of 1st gear then shifted. Making it spin worse in 2nd
Old 03-21-2018, 10:32 PM
  #5  
jaden61
Melting Slicks
 
jaden61's Avatar
 
Member Since: Oct 2010
Location: Fair Oaks, California
Posts: 2,162
Received 335 Likes on 243 Posts
2017 C7 of the Year Finalist

Default

Launch control only work while in first gear, as soon as it shifts, the launch is over. Read the last sentence.
Old 03-21-2018, 10:40 PM
  #6  
jaden61
Melting Slicks
 
jaden61's Avatar
 
Member Since: Oct 2010
Location: Fair Oaks, California
Posts: 2,162
Received 335 Likes on 243 Posts
2017 C7 of the Year Finalist

Default

Part of page from owners manual...

The Launch Control feature will
initially limit engine speed as the
driver rapidly applies the accelerator
pedal to wide open throttle. Allow
the engine rpm to stabilize.
A smooth, quick release of the
brake pedal, while maintaining the
fully pressed accelerator pedal, will
manage wheel slip.

After the vehicle is launched, the
system continues in Competitive
Driving Mode (except Z51 and Z06
with Magnetic Ride Control) or
Performance Traction Management
(Z51 and Z06 with Magnetic Ride
Control).
Old 03-21-2018, 10:58 PM
  #7  
123sugey
Dig
Support Corvetteforum!
 
123sugey's Avatar
 
Member Since: Jan 2006
Location: Port Saint Lucie FLORIDA & HONDURAS
Posts: 4,801
Received 759 Likes on 515 Posts

Default

^^^ in the end.... you can much much be better without launch control. Period. Fact. Look at the cars not using it. ��
Old 03-21-2018, 11:18 PM
  #8  
jaden61
Melting Slicks
 
jaden61's Avatar
 
Member Since: Oct 2010
Location: Fair Oaks, California
Posts: 2,162
Received 335 Likes on 243 Posts
2017 C7 of the Year Finalist

Default

^^^ I agree but...
Without saying it, my answer explained why he spins in 2nd during launch control.
Old 03-22-2018, 02:43 AM
  #9  
Mike Jesse
Burning Brakes
 
Mike Jesse's Avatar
 
Member Since: Aug 2016
Location: Bremerton Wa.
Posts: 861
Received 265 Likes on 195 Posts
Default

If you are still running the stock MPSS tire, it will require an aggressive burnout to dead hook. Turn the T/C for best results.

Get notified of new replies

To Which setting is best for launch control? Sport 2 caused too much spinning




Quick Reply: Which setting is best for launch control? Sport 2 caused too much spinning



All times are GMT -4. The time now is 11:27 PM.