Z06 M7 - Will it break the tires loose..
#2
Melting Slicks
Not only in 2nd...3rd too! Car is a beast...Respect it!
The following users liked this post:
nytrorcr (06-10-2017)
#3
Yes it will! Of course less when the tires are warm and in summer time, but 650+ HP are definitely there.
Now this will only happen if you smash the accelerator. The Z06 is my daily car and is not a problem at all to drive quietly if you wish. Nannies are there and really help. Just be over careful on wet road and I strongely recommend to use the Wet mode when it pour rain.
:-)
Now this will only happen if you smash the accelerator. The Z06 is my daily car and is not a problem at all to drive quietly if you wish. Nannies are there and really help. Just be over careful on wet road and I strongely recommend to use the Wet mode when it pour rain.
:-)
#6
Racer
Member Since: May 2011
Location: Orlando Florida
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
#7
Nope not at all. I tried it numerous times today with traction control off and in track mode. Had her in 2nd, rpm around 4,500 and foot through the floor and just took off hard but no tire spin at all. Was actually a little disappointed.
#8
Drifting
It definitely should ...
#13
You figure if it's not breaking loose at 4500 Rpms then it definitely won't break loose at 2500 Rpms. The higher the Rpms the better chance of her breaking loose.
#14
Pro
Not necessarily. With these PD blowers, a lot of the peak torque is down low around 3-4K RPM. Sometimes I break loose at 3000 rpm but not at 4500.
#15
I played around with the entire power band from 2,000 to 5,000 rpms and I felt a much higher chance of her breaking loose on the higher band then the lower band. My Z06 is completely stock besides for the Borla X pipe.
#16
Not saying your wrong I am just saying in 2nd gear I feel a much better chance of her breaking loose in the higher Rpms. I actually feel more lag in the lower rpms in 2nd gear
#17
Melting Slicks
What is top speed in 1st and 2nd? What is mph at 3,000 rpm in 2nd?
#18
Pro
#19
Melting Slicks
Are people breaking them loose in 2nd going 30 - 50 mph?
#20