2300 TVS Heartbeat!
#81
Team Owner
Thread Starter
I'm waiting for my order from Mighty Mouse. His under blower device removing the blower from oil track. Doing both cars. Then the blower gets done and to the tuner.
#82
Safety Car
#84
Team Owner
Thread Starter
#85
Team Owner
Thread Starter
Ok blower is on and I'm finishing up in the morning!
Went pretty good this is a nice kit! Mighty Mouse kit is installed saying good bye to dirty exhaust tips and oil in the blower and the valves got a clean up as well.
5 pounds off the engine once you pull the foam insert under the stock blower.
Went pretty good this is a nice kit! Mighty Mouse kit is installed saying good bye to dirty exhaust tips and oil in the blower and the valves got a clean up as well.
5 pounds off the engine once you pull the foam insert under the stock blower.
Last edited by 3 Z06ZR1; 03-22-2018 at 02:21 AM.
The following users liked this post:
3 Z06ZR1 (03-30-2018)
#87
Team Owner
Thread Starter
The instructions were great and I just took my time. Still have a few hours left then I'll be going in for a tune. Hardest part is the two rear blower bolts one on each side they are a bitch and took more than an hour EACH. I like they went black instead of gray. If this thing makes 680 rwhp or better on 92 pump gas. I'll be ordering one for the other car. Only need about 45 rwhp more it should do that.
Goes on in a weekend.
Goes on in a weekend.
Last edited by 3 Z06ZR1; 03-22-2018 at 02:51 AM.
The following users liked this post:
3 Z06ZR1 (03-30-2018)
#89
Le Mans Master
The instructions were great and I just took my time. Still have a few hours left then I'll be going in for a tune. Hardest part is the two rear blower bolts one on each side they are a bitch and took more than an hour EACH. I like they went black instead of gray. If this thing makes 680 rwhp or better on 92 pump gas. I'll be ordering one for the other car. Only need about 45 rwhp more it should do that.
Goes on in a weekend.
Goes on in a weekend.
I know why you're saying at least 680WHP seenwhat you are doing there
#90
Drifting
Do you anticipate the need for extra fuel with the increase in airflow with 2300?
#91
Team Owner
Thread Starter
Last edited by 3 Z06ZR1; 03-22-2018 at 02:52 PM.
The following users liked this post:
illmac77 (03-22-2018)
#92
Supporting Vendor
Looks good, our expansion tank would be perfect to compliment it too. Oem quick connect fittings, lines up with the heartbeat, and has mount provisions for a mighty mouse can.
The following users liked this post:
3 Z06ZR1 (03-30-2018)
#93
Team Owner
Thread Starter
She is running! Two issues one the Halltech intake is too short.
The Throttle body sits about a half inch to the right.
Second is reduced power car would not move just idles so I'll have it towed to take to the tuner. Next week.
The Throttle body sits about a half inch to the right.
Second is reduced power car would not move just idles so I'll have it towed to take to the tuner. Next week.
#95
Drifting
Just thinking outside of the box, might consider cutting the intake tube after the MAF area and adding a rubber couple to get the length you need.
The following users liked this post:
3 Z06ZR1 (03-24-2018)
#96
Team Owner
Thread Starter
Got it running reduced power is gone and took a test drive all sounds good. Now to the tuner next week. Mod list is 2300 blower, Mighty Mouse Catch can and PCV reroute AR 2 inch coated headers, Halltch intake. MAMO PTB.
Last edited by 3 Z06ZR1; 03-25-2018 at 03:08 AM.
The following 2 users liked this post by 3 Z06ZR1:
ajrothm (03-26-2018),
Perf n Restore (03-25-2018)
#97
Le Mans Master
Member Since: Oct 2005
Location: Metro Detroit Michigan
Posts: 7,075
Received 1,816 Likes
on
1,084 Posts
What was causing the reduced power?
The following users liked this post:
Perf n Restore (03-25-2018)
The following users liked this post:
3 Z06ZR1 (03-25-2018)
#99
Team Owner
Thread Starter
Not sure but it has done it in the past before the new blower. Just leave it for a bit and it is fine. I'll talk my tuner about fixing it.
Hope I can get it in early this week for the tune. Really like it so far!
Great thing is the exhaust tips, intake valves and blower and blower intercooler should stay clean no more oiling. Doing the other car real soon as well!
Hope I can get it in early this week for the tune. Really like it so far!
Great thing is the exhaust tips, intake valves and blower and blower intercooler should stay clean no more oiling. Doing the other car real soon as well!
Last edited by 3 Z06ZR1; 03-26-2018 at 12:32 AM.
#100
Team Owner
Thread Starter
Finished up and have been driving around with the 2300 feels great just no WOT yet till the tuner checks it. But man it feels good!
Trying to get the tune friday
Trying to get the tune friday