Who says our blowers don't whine?
The following users liked this post:
badhabit_wb (01-31-2019)
#45
Supporting Vendor
The following users liked this post:
Nitrous Express & Snow Performance (02-03-2019)
#48
Safety Car
Member Since: Sep 2014
Location: in the country North Carolina
Posts: 4,248
Received 911 Likes
on
727 Posts
Will do. I'm actually getting some work done on a quarter panel that I threw a rock through at VIR so when I get that done I'm getting it inspected and then I'l bolt it on. I had to order the hood liner too since I have a 15. Hopefully one of us will have it on soon.
#49
I am anxious to get some feedback on this! I am thinking about one myself since I am planning on updating my tune soon. If I get one I will be sure to do a before/after dyno and give a full review.
The following users liked this post:
KCSHANER (02-05-2019)
#53
Drifting
I FINALLY got my NX cover installed today and DEAR GOD! It's unbelievable how much you can hear the whine now! Here's a video that should give you a good idea. To set it up for you: My Z06 is stock with the exception of a CAI. Windows are up, hood is down (obviously since I'm driving) and I'm in sport mode, so no gimping the exhaust sound
://www.youtube.com/watch?v=ZGzWAKEEQ3s
The following users liked this post:
Nitrous Express & Snow Performance (03-07-2019)
#54
Safety Car
Member Since: Sep 2014
Location: in the country North Carolina
Posts: 4,248
Received 911 Likes
on
727 Posts
Sounds good. I'm planning to swap out my sc this weekend with the newer style with the taller lid. If all goes well I'll try to get my NX lid installed as well. I may wait a week or so to see how the new sc does before I swap lids.
#56
Safety Car
Member Since: Sep 2014
Location: in the country North Carolina
Posts: 4,248
Received 911 Likes
on
727 Posts
There are a couple of cylinders that run lean with the old one. I'm also getting an occasional misfire that we can't find a cause for. I'm going to give this a shot and see how it does. I don't have a track day scheduled until April 10 so I really won't know if this helps until then. If it causes any problems I'll post them on the forum. I'm just doing a straight swap so hopefully no issues.
The following users liked this post:
Mikec7z (03-08-2019)
#58
Drifting
There are a couple of cylinders that run lean with the old one. I'm also getting an occasional misfire that we can't find a cause for. I'm going to give this a shot and see how it does. I don't have a track day scheduled until April 10 so I really won't know if this helps until then. If it causes any problems I'll post them on the forum. I'm just doing a straight swap so hopefully no issues.
Not the main one, no. I ordered a new one from trunk moneys. it was like $35 shipped. I didn't know there are 4 little ones around the center holes though, so those I had to reuse.
The following users liked this post:
badhabit_wb (03-07-2019)
#60
Tech Contributor
Member Since: Oct 1999
Location: Charlotte, NC (formerly Endicott, NY)
Posts: 40,078
Received 8,919 Likes
on
5,328 Posts
Bill
The following users liked this post:
Mikec7z (03-08-2019)