Gathering all Potential Front Dive Plane / Canard Options Thread...
#1
Melting Slicks
Thread Starter
Gathering all Potential Front Dive Plane / Canard Options Thread...
Like the title says, gathering all existing/discovered dive plane options.
Myself and others are hunting for different options and there are surprisingly a lot of them out there, i will link a few here after bit, but if anyone wants to go first, have at it.
Myself and others are hunting for different options and there are surprisingly a lot of them out there, i will link a few here after bit, but if anyone wants to go first, have at it.
#2
Melting Slicks
APR makes a set that I was interested in I emailed them, asking if they had any aero data, or made any meaningful downforce. They replied the primary objective was to steer air away from the turbulent wheel well sea. No data. They look good though
Link to what I believe is a forum vendor. They are much cheaper on eBay though.
https://www.westcoastcorvette.com/p-...and-sport.aspx
Link to what I believe is a forum vendor. They are much cheaper on eBay though.
https://www.westcoastcorvette.com/p-...and-sport.aspx
The following users liked this post:
Mikec7z (03-15-2019)
#3
Melting Slicks
Thread Starter
#4
Le Mans Master
Member Since: Aug 2001
Location: Savannah GA
Posts: 6,070
Received 280 Likes
on
213 Posts
Cruise-In IV Veteran
Mike so check this out. I purchased the APR carbon fiber dive canards first, put them up to my bumper, and honestly loved them. But then I saw these: https://www.ebay.com/itm/182204702668. I thought they looked a bit more my style and are also carbon fiber. I never installed my APR ones and my new ones from DarwinPRO arrived today and they look stunning! Actually they both are amazing quality top notch carbon fiber, but of course they aren't cheap for how small they are.
I will get my new ones installed tomorrow and get some pics. I will be selling my brand new never installed APR ones now.
I will get my new ones installed tomorrow and get some pics. I will be selling my brand new never installed APR ones now.
The following users liked this post:
Mikec7z (03-16-2019)
#5
Melting Slicks
Thread Starter
They seem to be the most functional thus far that i have seen.
Please put up the pics of both up next to the car, held on by hand is fine, and if you can make a video of how they sit on the car or maybe take some pics. I am interested if they can start lower toward the center front, and then go up high toward the outside, like in my drawings on my cutout thread.
Last edited by Mikec7z; 03-16-2019 at 12:39 AM.
#6
Le Mans Master
Member Since: Aug 2001
Location: Savannah GA
Posts: 6,070
Received 280 Likes
on
213 Posts
Cruise-In IV Veteran
Here you go I took these last week already put them back in box ready to ship so this is the best I can do. I will have my new ones on today will get some good pics of those.
The following users liked this post:
Mikec7z (03-16-2019)
#7
Melting Slicks
Thread Starter
thank you buddy