Tool to adjust wing angle
#41
Track Rat
Thread Starter
This is how I would do it:
-Loosen the back bolts (rear of car) & take out the front bolts ( front of car)
-The front bolt holes of the brackets is some what slotted
-Drop the wing in the bottom holes for more angle on your wing & top for less angle
When I get back home I can take photo's of the brackets for more clarity, if youd like.
-Loosen the back bolts (rear of car) & take out the front bolts ( front of car)
-The front bolt holes of the brackets is some what slotted
-Drop the wing in the bottom holes for more angle on your wing & top for less angle
When I get back home I can take photo's of the brackets for more clarity, if youd like.
The following users liked this post:
MustOBeenYellow2015Z (03-13-2019)
#42
Burning Brakes
I believe it's the other way around. Loosen the front bolts so the wing can pivot but you need to remove the rear bolts then raise or lower the wing. There are two fixed positions so it's not truly slotted. Make sure you note which way the bolts go back in as one half has a square surface like a carriage bolt.
#43
Burning Brakes
Sooo..
I did indeed misguide you & had it backwards, sorry!
Left side bracket..
Slotted rear bolt hole..
So the wing will “pivot” on the front bolt hole & adjust with the rear bolt hole.
So the wing will “pivot” on the front bolt hole & adjust up or down with the rear bolt hole. Hope this clears everything up, lol
I did indeed misguide you & had it backwards, sorry!
Left side bracket..
Slotted rear bolt hole..
So the wing will “pivot” on the front bolt hole & adjust with the rear bolt hole.
So the wing will “pivot” on the front bolt hole & adjust up or down with the rear bolt hole. Hope this clears everything up, lol
The following users liked this post:
Palantirion (03-14-2019)