Homemade jack pucks
#1
Drifting
Thread Starter
Homemade jack pucks
I made jacking pucks for my C6 with eye screws and hockey pucks. Im thinking the ZR1 aero needs more clearance. anyone out there double up the pucks (screw or bolt them together). Is the keyway slot in the chassis the same on a c7 as a c6? Or suggestions for ones to buy and where. Thx.
#2
Le Mans Master
I made jacking pucks for my C6 with eye screws and hockey pucks. Im thinking the ZR1 aero needs more clearance. anyone out there double up the pucks (screw or bolt them together). Is the keyway slot in the chassis the same on a c7 as a c6? Or suggestions for ones to buy and where. Thx.
#3
Le Mans Master
I've had no problems with single pucks and full length side skirts on my Z51. I don't think the ZR1 is any lower in that area. I can get my Quickjack with the rubber blocks and the pucks under the car just fine.
#4
Drifting
Thread Starter
Thanks for the replys guys. Car is stored back in U.P of Michigan and I want to be ready when I get home from AZ. Might be a while. The snow is piled up waste deep back there.
Last edited by Rinaldo Catria; 02-16-2019 at 03:30 PM.
#6
Pro Mechanic
Pro Mechanic
I made jacking pucks for my C6 with eye screws and hockey pucks. Im thinking the ZR1 aero needs more clearance. anyone out there double up the pucks (screw or bolt them together). Is the keyway slot in the chassis the same on a c7 as a c6? Or suggestions for ones to buy and where. Thx.
#7
Moderator
Reverse Logic makes double thick, Delrin jacking pucks. I use them on my 2012 ZO6 all the time.