Any Chip Burners in Ohio?
#1
Drifting
Thread Starter
Any Chip Burners in Ohio?
Anyone know of someone that does dyno testing and chip burning
in Ohio? I'm 40 miles from the Indiana line and about 25-30 miles North of Cincinnati.
Thanks for any help you can offer.
in Ohio? I'm 40 miles from the Indiana line and about 25-30 miles North of Cincinnati.
Thanks for any help you can offer.
#2
Safety Car
Next weekend, May 14 & 15, PCMforLess is going to being dyno tuning at Powerhouse Performance on the east side of Cleveland, both Alvan and Brian will be there........other end of the state for you, but a rare opportunity.......I am getting mine "tuned"...
#3
Drifting
Thread Starter
Thanks for the info. You're right, it is a good ways off to Cleveland from here. I know there's a place up near Ft Wayne, Indiana (near Lingenfelter) that does this, but I'm still hoping to find someone a little closer to home.
#6
Drifting
Thread Starter
Last year at the "Corvettes On the Canal" at Bob McDorman CHevrolet.
(Canal Winchester, Ohio) there was an outfit there with a drive-on dyno that was charging either $50 or $75 / pull.
(Canal Winchester, Ohio) there was an outfit there with a drive-on dyno that was charging either $50 or $75 / pull.
#7
Safety Car
Originally Posted by corvette_bob
I know there's a place up near Ft Wayne, Indiana (near Lingenfelter) that does this, but I'm still hoping to find someone a little closer to home.
See my sig for what they built for me this winter.
http://www.dynotech-eng.com/
#8
Safety Car
Originally Posted by ROKNBLU
This may be off topic for the thread, but what is the going rate for DYNO testing at a typical DYNO DAY?
The dyno tuning at Power House Performance this weekend would be a good place to go see what it all about....I think they are going to allow some straight dyno pulls without getting requiring any tuning....but there probably could be some benefit from tweaking...
http://forums.corvetteforum.com/show...50&forum_id=43
BTW Powerhouse Performance has done quite few mods on C5's....
#9
Drifting
Thread Starter
Originally Posted by 2k1 Vette
The place in Ft Wayne that you are referring to is DynoTech Engineering. Yes, they are a bit of a drive (about 2.5 hours for me from Dayton) but they are well worth it.
http://www.dynotech-eng.com/
http://www.dynotech-eng.com/
#10
Safety Car
Originally Posted by corvette_bob
Last year at the "Corvettes On the Canal" at Bob McDorman CHevrolet.
(Canal Winchester, Ohio) there was an outfit there with a drive-on dyno that was charging either $50 or $75 / pull.
(Canal Winchester, Ohio) there was an outfit there with a drive-on dyno that was charging either $50 or $75 / pull.
They just had a dyno day last weekend......$75 is more like it, not $50..
http://www.backstreetper.com/index.htm
#11
Melting Slicks
Member Since: Feb 2003
Location: Construction Sucks! MI
Posts: 2,770
Likes: 0
Received 0 Likes
on
0 Posts
Cruise-In V Veteran
St. Jude Contributor '03 & '05
Originally Posted by ROKNBLU
This may be off topic for the thread, but what is the going rate for DYNO testing at a typical DYNO DAY?