CorvetteForum - Chevrolet Corvette Forum Discussion - Conversation Between BerniesVette and FRSTR90

Go Back  CorvetteForum - Chevrolet Corvette Forum Discussion > BerniesVette
Reload this Page >

Conversation Between BerniesVette and FRSTR90

Conversation Between BerniesVette and FRSTR90
Showing Visitor Messages 1 to 3 of 3
  1. FRSTR90
    09-15-2009 05:07 PM
    Bernie,
    Are you talking about where the mechanical linkage goes? If I PMed you with some pics, do you think you can tell me if I am thinking of the right place?
  2. BerniesVette
    09-15-2009 08:14 AM
    From inside the car on the firewall you can see the location for a hydraulic master cylinder. Just drill the 3 holes in the firewall and the master cylinder will bolt right in. I cut the rod on the master cyl. and threaded it to make it adjustable to get the length exact.
    Bernie
  3. FRSTR90
    09-15-2009 01:33 AM
    Hey Bernie,
    I was looking through the archives and saw a thread where you retro fitted an '85 slave cylinder. If I get this straight from what you posted, all I have to do is shorten the rod to where the slave cylinder can be flush to the firewall in the stock location and I should have the correct angle?

    Thanks
    John
Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.