CorvetteForum - Chevrolet Corvette Forum Discussion - View Profile: Mike@NorrisMotorsports


[email protected] Mike@NorrisMotorsports is offline

Supporting Vendor

About Me

  • About [email protected]
    Full Name
    Mike Norris
    Indianapolis Indiana
    Corvette Tech, Performance Shop Owner
    Country of Residence
  • Signature
    Mike Norris Motorsports
    660 Andico Road, Unit C
    Plainfield, IN 46168
    [email protected]

    Your LSx Performance & Corvette Specialist Since 1999


Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 10-02-2018 02:44 PM
  • Member Since: 07-09-1999


Showing Friends 1 to 7 of 7

Visitor Messages

Showing Visitor Messages 1 to 8 of 8
  1. Mike@NorrisMotorsports
    07-06-2010 08:39 AM
    It is probably best to give me a call so we can go over what was done and what is wrong to come up with a plan. The way my schedule is now it may not be till the end of this month or early August before I can do anything, but first lets talk about what we need to do. 407-616-2518
  2. JAW 94
    07-06-2010 07:56 AM
    Mike, I had a speed shop work on my car.....and I am looking for engine and transmission repairs. When will you be capable of taking on this type of repair?
  3. Mike@NorrisMotorsports
    03-21-2010 06:27 PM
    I would think that the Predator may overwrite what I had in there, but not sure. I did use LS1 Edit and it is un locked, so it could be that it does not see a stock tune. Again, not sure on what the predator would look for. If need be you could send me the PCM and I can make the change for you. It would run $100. Just let me know. Mike
  4. ipuig
    03-21-2010 03:30 PM
    You tuned my 01 Navy blue 01 coupe in May of last year while you were still in Winter Garden, car runs fine thanks.
    I recenlty installed a new cam shaft, not too radical 219/225 .510" 114 LSA. I'd like to raise the idle speed a bit (100 RPM) but the predator hand held programmer does not seem to be able to access the PCM's program any more, was your tunning program password protected some how, any ideas? Thanks.
  5. Mike@NorrisMotorsports
    11-25-2009 07:32 AM
    No problem at all with posting the video Richard. Thanks for the kind words also. Mike
  6. blackula 99
    11-22-2009 06:03 AM
    Wanted to thank you again for the dyno and tune back in September...great job! Question for you though,if you remember ,I made a video of my car being dynoed and tuned at your shop,do you have any problem with me putting it on "you tube"? Let me know...thanx again
  7. Mike@NorrisMotorsports
    09-29-2008 07:13 AM
    The unit came off of a 2008 LS3, so the answer is yes. It has all the hardware the comes with a new one. You can tell it is used as it has a couple marks on it and the filter shows it was working. A little rubbing on the small marks and cleaning the filter would make it as close to new as possible. But for almost half price you expect a little wear to show. I do not have any Bee Hive to go with it in this case. Just let me know and thanks.
  8. Safe Guy
    09-28-2008 10:43 PM
    I just want to confirm it will fit a 2008 LS3? I realize it is used but I am wanting "like new" condition, and Unit is complete with all fasteners and clamps etc.? Do you have a Beehive you might throw in with it? (never hurts to ask)
Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.