F/S Engine tranny and all the goodies
#1
Burning Brakes
Thread Starter
F/S Engine tranny and all the goodies
Hey all,
I'm probably getting ahead of myself here so here is chance for you to think ahead too! LOL
I have currently in my vette and will be removing in late summer or fall
1) Ramjet 350 GM crate engine complete with wiring and computer
2) 2004R Bowtie overdrives "Stage 2" transmission
3) Laptop with MEFI tuning software + factory tune + tune specific for my car
4) Mini Hi torque starter
5) small block hugger headers
6) original 69 sb radiator recored with 4 core high flow
7) very clean after market fuel tank ( 1969 )
8) Chrome single wire alternator
9) shorty water pump
10) Vintage Air compressor only ( I'll keep the rest )
11) proper external fuel pump to feed Ramjet
12) 2100 stall very streetable locking torque converter
OK, I think that is everything. Maybe a few more items I don't need.
I will be doing a drive train swap this fall. I would love to sell as a set to someone with a rolling C3 body. This could get you on the road very quickly with 350 hp and 400 ftlbs of reliable torque! All parts were installed brand new in my 69 and have limited miles on them.
All parts are currently in my vette and will stay there until I sell them.
I will not sell minor items separately unless motor and tranny are sold first.
Over 10K invested for the entire setup. Shhhhhh! don't tell my wife! LOL!
If anyone is seriously interested and in planning phase of a project, this might be an extremely reliable way to get your ride on the road.
If you have a very cheap early C3 in need, I might buy it, load it with this stuff and off it. It all depends!
Contact me here if interested and I'll share personal contact info.
Anytime you see me on the road, cruisin or wherever just stop me for a look and a ride.
Red 69 Convertible "69Shark" plates
Thanks
Scott
Mill Creek / Silver Lake area
I'm probably getting ahead of myself here so here is chance for you to think ahead too! LOL
I have currently in my vette and will be removing in late summer or fall
1) Ramjet 350 GM crate engine complete with wiring and computer
2) 2004R Bowtie overdrives "Stage 2" transmission
3) Laptop with MEFI tuning software + factory tune + tune specific for my car
4) Mini Hi torque starter
5) small block hugger headers
6) original 69 sb radiator recored with 4 core high flow
7) very clean after market fuel tank ( 1969 )
8) Chrome single wire alternator
9) shorty water pump
10) Vintage Air compressor only ( I'll keep the rest )
11) proper external fuel pump to feed Ramjet
12) 2100 stall very streetable locking torque converter
OK, I think that is everything. Maybe a few more items I don't need.
I will be doing a drive train swap this fall. I would love to sell as a set to someone with a rolling C3 body. This could get you on the road very quickly with 350 hp and 400 ftlbs of reliable torque! All parts were installed brand new in my 69 and have limited miles on them.
All parts are currently in my vette and will stay there until I sell them.
I will not sell minor items separately unless motor and tranny are sold first.
Over 10K invested for the entire setup. Shhhhhh! don't tell my wife! LOL!
If anyone is seriously interested and in planning phase of a project, this might be an extremely reliable way to get your ride on the road.
If you have a very cheap early C3 in need, I might buy it, load it with this stuff and off it. It all depends!
Contact me here if interested and I'll share personal contact info.
Anytime you see me on the road, cruisin or wherever just stop me for a look and a ride.
Red 69 Convertible "69Shark" plates
Thanks
Scott
Mill Creek / Silver Lake area
Last edited by 69_Shark; 06-22-2017 at 04:56 PM.