BTR 0.660 Platinum Valve Spring Kit
01-20-2019, 12:49 PM
#1
1st Gear
Thread Starter
Member Since: Jan 2019
Location: Oklahoma City, Oklahoma
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
BTR 0.660 Platinum Valve Spring Kit
Hello, I just bought new 243 heads with platnum 0.660 valve springs and a 1.725 lift already installed. The motor is stock but was going to put in LS7 lifters and LS2 trays.
Do I need to measure and get new pushrods. Will that lift create any issues with anything else if I don’t run a cam or boost for awhile?
Do I need to measure and get new pushrods. Will that lift create any issues with anything else if I don’t run a cam or boost for awhile?
Last edited by WallaceGavin; 01-20-2019 at 12:50 PM.
