Got my car back today from a cam/headers install! (Vid Inside)
 

Just wanted to share this quick video and my dyno numbers with you all, let me know what you think!!

02 Z06 with Texas Speed longtubes and x-pipe, Bullet custom grind cam with titanium springs/retainers, hardened pushrods, and tuned by Scott at InTune Motorsports in Charelston, TN. If anyone in the TN/GA/AL area is in need of some work give them a call, 423.336.5850!! I can't say enough good things about the guys up there and Scott can really work some magic with a few hours and a laptop.

Idle vid:
http://www.youtube.com/watch?v=-efRZEdRK10

Dyno sheet:
http://i23.photobucket.com/albums/b3...SC00586web.jpg

Sounds great! Send me a PM of what they charged you. I really need a cam after hearing your car!

WaBaa WaBaa! Love the lope. :thumbs: :bigears :thumbs:

PM sent!
Thanks guys!! :cheers:

:iagree: love the lope. whats the grind on the cam?

am I reading that graph right....that it made 382 rwhp. I would have thought it would have been more.

Mustang dyno's read lower. Probably 420rwhp on dyno jet.

Yeah I thought it should be around that with just headers and a tune.

sounds awsome man! i would like the cam specs also,getting ready for cam lts and tune myself!
by the way,did you get a base dyno pull?:cheers:

Still only 26hp over stock... sounds killer though.

Wrong, that would be 420HP to the wheels as opposed to the 405HP stock to the flywheel. So probably around 485 to the flywheel(guessing) so that would put it at approx 80+HP over stock.

Car sounds great man!:thumbs:

From what I can tell 60 whp was gained? It's late and im tired though...

Thanks man! The cam is 236/240 .603/.612 112+4 :thumbs:

As stated it was on a Mustang dyno and is inline with other Z's they've done. Most locals refer to this dyno as "The Heartbreaker". For reference my old 03 Cobra made 492/476 when tuned at MPH on their dynojet and made 416/408 on this mustang dyno.

Thanks man! Cam specs are right ^^ up there. They did a base pull w/ just the headers on (how it was when I brought it in) and it made in the 33x whp range.

Scott (my tuner) said bone stock Z's usually make about 310-320 whp on his dyno so you sir are about right on!! :cheers:

Thanks for all the compliments guys!

Here's a quick in car video, from ~20-120 mph. (Sorry in advance for the crappy quality)

http://www.youtube.com/watch?v=fX8Dd7Nn3pg

^^^very nice :thumbs:

Do you have your skip-shift set up as a shift light?

^ I noticed that too. Is there a DIY somewhere? That's awesome :thumbs:

talked to scott at intune motorsports, very helpful, with lots of great info, thanks scott!:thumbs:

love the vid:yesnod:

The skip-shift light can be setup as a regular shift light with just about any tuning software. In this instance, Scott uses HPT and will turn it on if you ask.