Rear diffuser removal and questions
 

Can this be done without jacking the car up and without removing wheels and liners? Just looking to do it without all these extra steps even if it takes longer in the end.

:cheers:

You do not have to remove the wheels and liners. I do recommend jacking up to get to the screws that are hard to reach

It would be hard to do. I ended up removing the rear wheel and peeling back the liner. There are hex screws that are inside down the sides of the diffuser that are really hard to get too. I ended up going and buying a air ratchet, if you don't have one, I would recomned getting it, it will make the job so much easier and faster. There really is very little room to maneauvre inside the diffuser.
I was installing the ACP one so the bottom comes back a lot further which made it harder, if you aren't installng one of those then it can be done without removing wheels with an air ratchet.
Depending on how big you are would depend if you need to jack it up at the rear or not, but thats not so hard to do.
:cheers:David

I have instructions on how to remove the rear valance. If you'd like it PM me your email address and I'll be glad to send it to you.

Sales@empirecorvettes.com

Thanks!

remove diffuser
 

if someone can email me the directions to the removal of the diffuser as well, I would greatly appreciate it
barry@cslllconline.com

Does anybody have a copy of the replacement instructions that you can send me?

Thanks.

jimtraylor@hotmail.com

https://www.corvetteforum.com/forums/c6-tech-performance/2484347-rear-diffuser-removal-diy.html


http://talk-auto.com/chevrolet-service-manuals/chevrolet-corvette-c6-z06-rear-diffuser-installation-manual/