Retro Belt Factory Style Seat Belt Replacements On Sale **$199.99 SHIPPED**
 

Do you have any pics of them installed?

Thanks, Les :cheers:

I've asked the mfg.

also 1969?

May be able to retro fit, but they aren't offered by this mfg.

Is this price for a set of two?

yes, it is

Good price, nice looking too, good luck with this promotion and sale. :thumbs:

I've got a 73 that had the shoulder / lap belts. At the web site there are ttwo different replacement sets listed, 1970-1973 Single Retractor 3 Point and 72-73 Dual Retractor 3 Point. I'm assuming the original equipment was a dual retractor set up, BUT I'd rather a more modern single retractor system. Is that the differance between the two setups listed at the web site? Also could you post the installation instructions for each seat belt set so I could get a better idea of setup differances? Thanks, Russ.

corvettemods1,

I now see the difference between the two seat belt setups for the 1973 Corvette. Can either be used when the original vehicle seatbelt system was with shoulder / lap belts? Is it personal prefferance or is the single retractor an upgrade for people who only had lap belts? I'm asking so many questions because the only portion of the seat belts left in my car is the shoulder retractor, the previous owner must have pulled the seat belt latch and lap portion of the belt setup when putting in new carpet and never got to replacing the belts, so I don't know what was in the car other than the fact that the shoulder retractor is still there and in place. I'm not sure I like the idea of having a retractor under the seat..... I'm not into anything other than making the car safe to drive as in having working seatbelts. The web site does not give much info other than the fact that two versions are made for the 73 vette. Furthermore I don't want to purchase something that is not going to fit my car. Any information will be most appriciated. I want to make the purchase while you still have your sale running so please any info will help. Thanks, Russ.

Please pm us with a list of specific questions and on Monday we will call the mfg for you and advise. thx

I'm with rberman999 on the retractor question plus how does one get the belt through the slot on my 71 seat back since the pic shows the rubber sleeve attached to the belt. those sleeve are not very pliable.
Mike

I'm glad I saw this post.. ordered a new set for my 76 C3 in brown. saved a few bucks.. I would assume these belts are a direct bolt-in.

Thanks,

Mike

Corvettemods1,

Are these seat belt sets American made? If not where are they made? Last question before I purchase (assuming they are Amercan made). Thanks, Russ

Do you have a set made in the USA? I understand it will be more money and that is ok within reason (you mentioned $75 and that is fine). If you do offer them where could I see pictures and get info?

We do, and we will be updating this thread shortly with another offering!

:thumbs:

I received my set, but the buckle side is about 4" longer than the rubber sleeve. Is it supposed to be like that?

email us a picture so we can find out. thx

sales@corvettemods.com

Email sent. Here are the pics for others to see.

http://img.photobucket.com/albums/v3...ps385a7cde.jpg

http://img.photobucket.com/albums/v3...psec5165ed.jpg