cam labor?
I already have an aftermarket cam installed but I just bought a novi 1500 kit. If I decide to have the shop swap the cam during the install for a blower cam how much additional labor is involved? springs and rods done already. Thanks
|
Probably about 6-8 hours as they'll want to charge but realistically I think it could be done much faster.
|
Originally Posted by That_White_C6
(Post 1594110786)
Probably about 6-8 hours as they'll want to charge but realistically I think it could be done much faster.
You don't rush it when doing heart surgery. A lot of work involved here, radiator out and HB pulled takes a little more time. |
The HB gets pulled during the sc install anyway right?
|
Originally Posted by magic c6
(Post 1594114891)
The HB gets pulled during the sc install anyway right?
OP: If the cam works great NA, it should work (at least) good with boost. Mind sharing cam specs on whats already installed? |
Originally Posted by magic c6
(Post 1594114891)
The HB gets pulled during the sc install anyway right?
|
I have an ATI balancer going in. specs are
- 230/242 .612 114LSA Custom put down 498whp. want to put down 650ish. Do I need a cam? Do I need meth? |
If you are already there, put on a balancer that won't have the chances of failing like a stocker and make you go in again.
|
Originally Posted by magic c6
(Post 1594115048)
I have an ATI balancer going in. specs are
- 230/242 .612 114LSA Custom put down 498whp. want to put down 650ish. Do I need a cam? Do I need meth? |
Originally Posted by irok
(Post 1594126896)
you don't need the cam and will be much better with meth at that power level
|
That cam will be just fine with the novi imo.
|
All times are GMT -4. The time now is 10:35 PM. |
© 2024 MH Sub I, LLC dba Internet Brands