236 MPH 1/2 mile. corvette and Rwd record
 

clicked off a 236.1 mph half mile pass at this most recent Shifts3ctor/Neverlift half mile event. reset the corvette and the RWD halfmile record. been chasing this one for awhile with this build and finally snagged it. same set up the car has been since last season, just getting it really dialed in finally. shooting for upper 240's 250s at the up coming shifts3ctor event at pikes peak CO. Few pics from the event below.

Speedhunters write up on the weekend out aswell
http://www.speedhunters.com/2018/05/...s-c6-corvette/

https://cimg1.ibsrv.net/gimg/www.cor...ec13775ed5.jpg

https://cimg2.ibsrv.net/gimg/www.cor...27745c5a59.jpg

https://cimg3.ibsrv.net/gimg/www.cor...8a68b7b792.jpg

https://cimg4.ibsrv.net/gimg/www.cor...f3c283e669.jpg

https://cimg5.ibsrv.net/gimg/www.cor...b1f3039746.jpg

https://cimg6.ibsrv.net/gimg/www.cor...5a7c563b56.jpg

https://cimg7.ibsrv.net/gimg/www.cor...1e82d0f0c4.jpg

Just bad ass!! Look at your rear tires being loaded.. ��

that one was just short of the finish line , roughly 220-230 mph

Congrats, your car is a BEAST!!!!

Congratulations, awesome achievement

That is fucking flying !!!!

Insane

Congratulations on a job very well done. How is the down force on your front end handled? Are you using exhaust gas pressure instead of a splitter?

front end stays down really well with out a splitter, just a sealed front. side exit exhaust. nothing fancy up there

video of the run

That thing is hauling serious ass. What’s the rear wheel setup? Those frickin tires are HUGE. How did you get those to fit? Mini tubs?

I'm surprised the car is table with those tyres, unless the rear wing helps a lot with that ?

His car is badass, well all his cars are badass.

Yes it is minitubed to run the big boy ET street Rs.

Just crazy

Congrats man.. That thing is hauling!

Just a wee bit of rear downforce :lol:

That thing is cruising! Did you end up fitting those 16" wide tires?

Its a 15x10 Weld RTS in standard c6 z06 fitment. The 325 50 15 Street R fit no problem on the stock fenderwells and fenders. but the 315 60 15 Pro's rubbed very badly, so over this winter i snagged the vengeance racing tubs and 1.5" supervettes rear fenders from Ron to better clearance the 315 pro's

no stability issues at all on the 315 pros or the 325 street R with or with out the wing. car has always gone straight with out a fuss

havent tried yet since they havent released but im pretty sure they wont clear with out cutting up the fenders alot more than i already have