Fuel Pressure Numbers
92 LTI, with Bosch IIIs.
Just installed a new Delphi with Strainer, removed pulsator. New GM fuel Filter. After 5 ignition cycles 22 psi but it holds steady for a half hour. Running is 38 (so slightly below what the FSM calls for). 56 with FPR disconnected No fuel in vacuum fitting. As soon as you turn car off drops back to 22 psi and hold. Eventually drops to 10 after about 2 hours. Little bit of a stumble at idle, hot days in traffic. Is it time to replace the regulator? |
….. Engine off fuel pressure will have ZERO affect on hot engine idle …..
|
Originally Posted by belairbrian
(Post 1597595801)
92 LTI, with Bosch IIIs.
Just installed a new Delphi with Strainer, removed pulsator. New GM fuel Filter. After 5 ignition cycles 22 psi but it holds steady for a half hour. Running is 38 (so slightly below what the FSM calls for). 56 with FPR disconnected No fuel in vacuum fitting. As soon as you turn car off drops back to 22 psi and hold. Eventually drops to 10 after about 2 hours. Little bit of a stumble at idle, hot days in traffic. Is it time to replace the regulator? 56 is high with the vacuum line disconnected. Either the pump is putting out to much pressure or there is a restriction back to the tank for the return flow With the vacuum line connected and you rev the engine half throttle for a second the pressure should jump to about 40. If you are much higher than this there might be too much instant pressure for the injectors hence making it to rich causing a stumble. Just a theory |
Hey guys new here and new vet owner got a 92 I’m having problems I’m getting around 34 pounds pressure starts and runs for a while heats up and dies not sure have replaced fuel filter and regulator not sure what next thinking injectors the ones in it the resistance on them is all I’ve from 11.93 to 12.21 any ideas ??
|
Originally Posted by Batman35
(Post 1597611575)
Hey guys new here and new vet owner got a 92 I’m having problems I’m getting around 34 pounds pressure starts and runs for a while heats up and dies not sure have replaced fuel filter and regulator not sure what next thinking injectors the ones in it the resistance on them is all I’ve from 11.93 to 12.21 any ideas ??
As to the injectors, if they are Multec, dump them. With ethanol, it could be an issue since the coil windings and ethanol don't get along and you will be forced to go to gas stations that have 93 octane 100% gas which will be a PITA. https://cimg1.ibsrv.net/gimg/www.cor...e2f166abad.jpg |
All times are GMT -4. The time now is 12:42 PM. |
© 2024 MH Sub I, LLC dba Internet Brands