CorvetteForum - Chevrolet Corvette Forum Discussion

CorvetteForum - Chevrolet Corvette Forum Discussion (https://www.corvetteforum.com/forums/)
-   C3s for Sale/Wanted (https://www.corvetteforum.com/forums/c3s-for-sale-wanted-56/)
-   -   FS: 1968 Convertible (Base) (https://www.corvetteforum.com/forums/c3s-for-sale-wanted/4258831-1968-convertible-base.html)

2019GSTX 04-02-2019 01:45 PM

1968 Convertible (Base)
 
3 Attachment(s)
**SOLD**
Gentlemen:
I've decided to put my 1968 Polar White Convertible up for sale. At this point in my life I just have too much other stuff going on and don't have time to drive, or work on it, anymore.
I'll give ya some of the particulars and you can read the attached appraisal report from last summer for more info. As per the report, the stated market value and sale price is $22,500.
CAR HISTORY
My ex-wifes grandfather was a fighter pilot serving in Vietnam in the spring of 1967. I guess he wanted a new Corvette so he went to the Chevrolet dealer in Saigon and ordered a 1968. I have a book full of documents from the dealership, some of them can be seen in the attached appraisal. As it was back in the day, there are several type written letters between him and GM concerning the ordering and picking up of the car. In October 1967 when he returned from Vietnam he picked the car up at Community Chevrolet in Las Vegas. He later moved to St Pete, FL and that's where I first came across the car. He was getting up in years and in 1997 I convinced him to sell the car to me. It been in my possession or the last 22 years. I have receipts for a lot of things he replaced on the car, including the paint job in 1983, the engine rebuild @ 98k mi. to run unleaded and most every little piece part that was replaced. I've kept receipts all thru my ownership.

327 cu in/300hp
Numbers matching
Polar White ext/Bright Blue int
4 spd manual trans
Air Conditioning (currently off the car)
White Top (needs to be replaced)
Radio Delete (plate installed in center console/no ignition shielding under hood)
Converted to Pwr Steering back around 2001
VB&P Fiberglass Spring
4 wheel disk brakes - standard (not pwr brakes)
Currently running chambered stainless straight pipes but have replacement mufflers and original exhaust tubes
Carb rebuilt a few months ago due to leaking inlet fitting

The car by no means is perfect, it need some attention. As stated, the convertible top needs to be replaced and I have an Al Knoch replacement on hand. The air conditioning compressor needs to be rebuilt but I have all the lines and components boxed up. The appraisal shows the old interior, I replaced the carpet with new so It looks much better. The paint is what you would expect for 36 year old lacquer. It needs to be touched up in places or re-painted. I have some extra parts, some new but most are ones that I have replaced on the car.

PM please if you are interested, I can send more pics or set up a phone call to discuss or answer any questions.
Thanks for looking!
(I'll post up more pics later, trying to get this done at work)



https://cimg1.ibsrv.net/gimg/www.cor...b8dd975272.jpg

kaman 04-02-2019 09:03 PM

I think its worth more than that

2019GSTX 04-02-2019 09:23 PM

A few more pics
https://cimg6.ibsrv.net/gimg/www.cor...729034a67.jpeg
https://cimg8.ibsrv.net/gimg/www.cor...801231356.jpeg

2019GSTX 04-02-2019 09:51 PM

Body Mounts @ Kickpanels
https://cimg3.ibsrv.net/gimg/www.cor...96f28e5abb.jpg
https://cimg5.ibsrv.net/gimg/www.cor...59e7482671.jpg

2019GSTX 04-02-2019 09:55 PM

Numbers matching car....
https://cimg9.ibsrv.net/gimg/www.cor...5e660ce024.jpg
https://cimg0.ibsrv.net/gimg/www.cor...d72e048321.jpg
https://cimg2.ibsrv.net/gimg/www.cor...d11f91a682.jpg
https://cimg8.ibsrv.net/gimg/www.cor...0131be90a6.jpg

Bruce42 04-18-2019 09:24 PM

Very nice car for the money.

CA-Legal-Vette 04-19-2019 06:12 PM

Looks really good. I’m sure it’s a blast to drive. GLWS!

Paleden 04-19-2019 11:43 PM

What are you asking for it? Thanks

jimrowe0 04-20-2019 06:16 AM


Originally Posted by Paleden (Post 1599259290)
What are you asking for it? Thanks

it says 22,500 in the ad.

2019GSTX 05-07-2019 03:40 PM

BUMP
Price reduced to 20,000.
Carpet has been replaced, the carburetor rebuilt, a few other little odds and ends. New tires on the front (235's) so no rubbing.
The car is ready to go!
Let me know if you have any questions.
She needs a little work as described in the original post but its a well documented numbers matching car!

Jim Vette 05-08-2019 12:52 AM

Is it still available?
 

Originally Posted by 2019GSTX (Post 1599155231)
Gentlemen:
I've decided to put my 1968 Polar White Convertible up for sale. At this point in my life I just have too much other stuff going on and don't have time to drive, or work on it, anymore.
I'll give ya some of the particulars and you can read the attached appraisal report from last summer for more info. As per the report, the stated market value and sale price is $22,500.
CAR HISTORY
My ex-wifes grandfather was a fighter pilot serving in Vietnam in the spring of 1967. I guess he wanted a new Corvette so he went to the Chevrolet dealer in Saigon and ordered a 1968. I have a book full of documents from the dealership, some of them can be seen in the attached appraisal. As it was back in the day, there are several type written letters between him and GM concerning the ordering and picking up of the car. In October 1967 when he returned from Vietnam he picked the car up at Community Chevrolet in Las Vegas. He later moved to St Pete, FL and that's where I first came across the car. He was getting up in years and in 1997 I convinced him to sell the car to me. It been in my possession or the last 22 years. I have receipts for a lot of things he replaced on the car, including the paint job in 1983, the engine rebuild @ 98k mi. to run unleaded and most every little piece part that was replaced. I've kept receipts all thru my ownership.

327 cu in/300hp
Numbers matching
Polar White ext/Bright Blue int
4 spd manual trans
Air Conditioning (currently off the car)
White Top (needs to be replaced)
Radio Delete (plate installed in center console/no ignition shielding under hood)
Converted to Pwr Steering back around 2001
VB&P Fiberglass Spring
4 wheel disk brakes - standard (not pwr brakes)
Currently running chambered stainless straight pipes but have replacement mufflers and original exhaust tubes
Carb rebuilt a few months ago due to leaking inlet fitting

The car by no means is perfect, it need some attention. As stated, the convertible top needs to be replaced and I have an Al Knoch replacement on hand. The air conditioning compressor needs to be rebuilt but I have all the lines and components boxed up. The appraisal shows the old interior, I replaced the carpet with new so It looks much better. The paint is what you would expect for 36 year old lacquer. It needs to be touched up in places or re-painted. I have some extra parts, some new but most are ones that I have replaced on the car.

PM please if you are interested, I can send more pics or set up a phone call to discuss or answer any questions.
Thanks for looking!
(I'll post up more pics later, trying to get this done at work)



https://cimg1.ibsrv.net/gimg/www.cor...b8dd975272.jpg

Is it still available?

2019GSTX 05-08-2019 12:45 PM


Originally Posted by Jim Vette (Post 1599362719)
Is it still available?

Hey Jim,
Yes it is sir!
Tucked away in the garage as we speak...
Let me know if you have questions, need pics or anything.

Jim Vette 05-08-2019 11:28 PM

Vette for sale
 
Please send pics to Jim.mckay63@6ahoo.com


Originally Posted by 2019GSTX (Post 1599365236)
Hey Jim,
Yes it is sir!
Tucked away in the garage as we speak...
Let me know if you have questions, need pics or anything.


Ramets 05-16-2019 07:53 AM

Is the interior blue or black?

2019GSTX 05-16-2019 09:50 AM

The interior is blue

Corey_68 05-19-2019 11:39 AM


Originally Posted by 2019GSTX (Post 1599359767)
BUMP
Price reduced to 20,000.
Carpet has been replaced, the carburetor rebuilt, a few other little odds and ends. New tires on the front (235's) so no rubbing.
The car is ready to go!
Let me know if you have any questions.
She needs a little work as described in the original post but its a well documented numbers matching car!


Wish I had the room, hell of a price for what appears a very straight original car!

GLWS, I'd contact the Texas/ Dallas NCRS president, might help/know someone in the market. :cheers:

2019GSTX 05-19-2019 11:55 AM

Thanks Corey
i’ll give that a try...

corvetteronw 05-28-2019 08:32 PM

Interesting. I was born in Denton and I am a US Army veteran of Vietnam. We really appreciated those fly boys. My youngest son currently lives in McKinney and is a buyer there for JC Penney.
That is great country for Corvette cruising!
GLWS


All times are GMT -4. The time now is 08:56 AM.


© 2024 MH Sub I, LLC dba Internet Brands