09' Z06 - built 427 LSX - 19k miles - 3LZ optioned.
Up for sale is my 2009 Corvette Z06 with the 3LZ option package and 19,900 miles (will continue to drive vehicle). The 3LZ interior package does a lot for the interior look and feel. I am the original owner and the title is IN HAND. LOADED with navigation, heated seats, full wrapped and stitched interior panels, etc. The stock LS7 engine has been replaced by a GM Performance Parts 427 LSX engine by SDPC. Engine cost alone was over $14,000! Selling due to me buying a new car recently.
Asking $37,995. -GM LSX block with Callies Dragonslayer crank,Ultra H-beam rods, and Wiseco pistons. -Brodix BR7 heads with titanium intake and stainless exhaust valves with PAC springs, and fully CNC ported by West Coast Cylinder Heads (WCCH) -Morel link bar lifters -RPS Billet triple carbon clutch -Dallas Performance camshaft -LSA injectors with Walbro 450lph in tank fuel pump. Car can run on flex fuel (gas or ethanol) -Hinson solid motor mounts -Cobalt fuel pressure and Wideband gauges -Vi-King dual adjustable shocks -Katech rear carbon fiber spoiler -AMP oil cooler -Halltech intake -RSD Roll bar and billet fire extinguisher mount -American Racing Longtube headers with 2" primaries and x-pipe. -Akrapovic bi-modal exhaust controller -Stoptech slotted rotors -Hawk Street/Race pads ****NOTES: There is a single scratch on the passenger rear quarter panel and some scuffs on the driver side front bumper that are visible if you look up close. Clear bra has been on the front 1/2 of the hood and front fenders since the car was purchased. Time has caused the front bra to cloud, especially on the passenger fender. The Hawk brake pads are a very aggressive compound and will create noise on braking while cold. The car used to have a Procharger system installed, but it has been removed and sold. Thank you for looking and please contact me for any additional information. These pictures were taken just yesterday! https://cimg3.ibsrv.net/gimg/www.cor...e4d1a6d85.jpeg https://cimg4.ibsrv.net/gimg/www.cor...89d61a660.jpeg https://cimg7.ibsrv.net/gimg/www.cor...ff3481455.jpeg https://cimg1.ibsrv.net/gimg/www.cor...e581dd8af.jpeg https://cimg4.ibsrv.net/gimg/www.cor...f66989814.jpeg https://cimg6.ibsrv.net/gimg/www.cor...a1b952139.jpeg https://cimg8.ibsrv.net/gimg/www.cor...40f1ac6af.jpeg https://cimg9.ibsrv.net/gimg/www.cor...f6a0d0fa9.jpeg https://cimg6.ibsrv.net/gimg/www.cor...929548ee4.jpeg https://cimg9.ibsrv.net/gimg/www.cor...381297e75.jpeg https://cimg1.ibsrv.net/gimg/www.cor...fddc3cd2a.jpeg https://cimg2.ibsrv.net/gimg/www.cor...1d534865f.jpeg https://cimg5.ibsrv.net/gimg/www.cor...4312a4b04.jpeg https://cimg8.ibsrv.net/gimg/www.cor...54fa0c97f.jpeg |
bump
|
bump
|
shoot me an offer!
|
How many miles on the LSX? Clutch?
Blower Cam? Has she been re-tuned since the blower was removed? Are those Aftermarket Wheels? |
Originally Posted by EX1
(Post 1599295571)
shoot me an offer!
|
Originally Posted by V60050
(Post 1599308308)
How many miles on the LSX? Clutch?
Blower Cam? Has she been re-tuned since the blower was removed? Are those Aftermarket Wheels? Wheels are stock GM wheels that have been refinished. |
Originally Posted by evo&stang
(Post 1599308659)
Why was the blower removed?
|
Originally Posted by EX1
(Post 1599213108)
Up for sale is my 2009 Corvette Z06 with the 3LZ option package and 19,900 miles (will continue to drive vehicle). The 3LZ interior package does a lot for the interior look and feel. I am the original owner and the title is IN HAND. LOADED with navigation, heated seats, full wrapped and stitched interior panels, etc. The stock LS7 engine has been replaced by a GM Performance Parts 427 LSX engine by SDPC. Engine cost alone was over $14,000! Selling due to me buying a new car recently.
Asking $39,999. -GM LSX block with Callies Dragonslayer crank,Ultra H-beam rods, and Wiseco pistons. -Brodix BR7 heads with titanium intake and stainless exhaust valves with PAC springs, and fully CNC ported by West Coast Cylinder Heads (WCCH) -Morel link bar lifters -RPS Billet triple carbon clutch -Dallas Performance camshaft -LSA injectors with Walbro 450lph in tank fuel pump. Car can run on flex fuel (gas or ethanol) -Hinson solid motor mounts -Cobalt fuel pressure and Wideband gauges -Vi-King dual adjustable shocks -Katech rear carbon fiber spoiler -AMP oil cooler -Halltech intake -RSD Roll bar and billet fire extinguisher mount -American Racing Longtube headers with 2" primaries and x-pipe. -Akrapovic bi-modal exhaust controller -Stoptech slotted rotors -Hawk Street/Race pads ****NOTES: There is a single scratch on the passenger rear quarter panel and some scuffs on the driver side front bumper that are visible if you look up close. Clear bra has been on the front 1/2 of the hood and front fenders since the car was purchased. Time has caused the front bra to cloud, especially on the passenger fender. The Hawk brake pads are a very aggressive compound and will create noise on braking while cold. The car used to have a Procharger system installed, but it has been removed and sold. Thank you for looking and please contact me for any additional information. These pictures were taken just yesterday! https://cimg3.ibsrv.net/gimg/www.cor...e4d1a6d85.jpeg https://cimg4.ibsrv.net/gimg/www.cor...89d61a660.jpeg https://cimg7.ibsrv.net/gimg/www.cor...ff3481455.jpeg https://cimg1.ibsrv.net/gimg/www.cor...e581dd8af.jpeg https://cimg4.ibsrv.net/gimg/www.cor...f66989814.jpeg https://cimg6.ibsrv.net/gimg/www.cor...a1b952139.jpeg https://cimg8.ibsrv.net/gimg/www.cor...40f1ac6af.jpeg https://cimg9.ibsrv.net/gimg/www.cor...f6a0d0fa9.jpeg https://cimg6.ibsrv.net/gimg/www.cor...929548ee4.jpeg https://cimg9.ibsrv.net/gimg/www.cor...381297e75.jpeg https://cimg1.ibsrv.net/gimg/www.cor...fddc3cd2a.jpeg https://cimg2.ibsrv.net/gimg/www.cor...1d534865f.jpeg https://cimg5.ibsrv.net/gimg/www.cor...4312a4b04.jpeg https://cimg8.ibsrv.net/gimg/www.cor...54fa0c97f.jpeg |
Originally Posted by Nketchum25
(Post 1599313804)
Would you take 36k?
|
Originally Posted by EX1
(Post 1599316083)
PM’d you
|
weekend bump
|
price drop!
|
pm'd
|
Shoot me an offer!
|
Sold
|
Originally Posted by EX1
(Post 1599422226)
Sold
Congrats brother!! Its hard to sell a modified car! |
Originally Posted by BRING IT
(Post 1599430139)
Congrats brother!! Its hard to sell a modified car!
|
Originally Posted by EX1
(Post 1599439374)
Thanks. I ended up just trading it in though on a new truck and taking advantage of the huge tax break in TX. Still can't believe nobody wanted a built LSX Z for less than book value :willy:
|
Originally Posted by EX1
(Post 1599439374)
Thanks. I ended up just trading it in though on a new truck and taking advantage of the huge tax break in TX. Still can't believe nobody wanted a built LSX Z for less than book value :willy:
|
All times are GMT -4. The time now is 07:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands