New 1974 casting lt1 short block sold
 

https://cimg4.ibsrv.net/gimg/www.cor...3a648aab6.jpeg
https://cimg6.ibsrv.net/gimg/www.cor...ffd6d6a2f.jpeg
https://cimg4.ibsrv.net/gimg/www.cor...e2430216d.jpeg
https://cimg7.ibsrv.net/gimg/www.cor...78cc65b87.jpeg
https://cimg6.ibsrv.net/gimg/www.cor...625a481c9.jpeg
https://cimg8.ibsrv.net/gimg/www.cor...ed9fc76a0.jpeg
https://cimg4.ibsrv.net/gimg/www.cor...d2157d90e.jpeg
https://cimg6.ibsrv.net/gimg/www.cor...f6425b4cc.jpeg
https://cimg8.ibsrv.net/gimg/www.cor...3c2aeec33.jpeg
https://cimg0.ibsrv.net/gimg/www.cor...41155e0fd.jpeg
https://cimg3.ibsrv.net/gimg/www.cor...70f5a32e6.jpeg
I have a lt1 short block that was manufactured in 74 that is new it has never been ran. It is a new block 4.0 bore,1182 forged crank, pink rods, forged dome pistons, 8” balancer, corvette oil pan with windage tray, oil pump with pickup,the cam is also installed i have not taken it apart to verify any numbers but i assume it is lt1 as well. The vin stamped pad shows a CE4359 number so it is a counter exchange/warranty block that was never installed. 2000 obo
the short block is located near Sacramento

This could be a nice find for somebody. A pic showing condition and the date code might help.

glws

Very nice is it local pickup only?

It can be shipped if the buyer is willing to pay shipping

Ttt
 

Ttt

That has never ever been fired? Why the rod missing?
Interested

It hasnt ever been fired it still has original grease on the bearings. The piston is not in the block because i took it out to inspect the bore and the crank to make sure it all looked good and its just sitting on the bench

Location?Any other parts?

I live in Thornton California it also has a manual flywheel with a clutch on it

Hemet, what can be worked out 92545

I would be willing to meet halfway or i could check on shipping charges monday

Ttt

That's a good buy...

Randy, sent you a PM.